Results 51 to 60 of about 621 (266)

Evaluation of CaCO3 clogging in emitters with magnetized saline waters

open access: yesDesalination and Water Treatment, 2012
Abstract High water application uniformity is essential for an effective irrigation. Clogging of emitters in drip irrigation systems is one of the most important factors decreasing uniformity. In this study, the possible effect of magnetization of water on chemical clogging of dripline emitters was investigated. Separate experiments were conducted with
ŞAHİN, Üstün   +2 more
openaire   +2 more sources

Interaction between Molten Al‐Killed Mn–B Steel and Carbon‐Bonded MgO Refractories Based on Recyclates

open access: yesAdvanced Engineering Materials, EarlyView.
High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé   +5 more
wiley   +1 more source

Influence and selection of nitrogen and phosphorus compound fertilizers on emitter clogging using brackish water in drip irrigation systems

open access: yesAgricultural Water Management
Emitter clogging is a major obstacle to the application of brackish water in drip irrigation systems, which can be aggravated with inappropriate fertilizer application.
Yayu Wang   +5 more
doaj   +1 more source

Influence of Sample Preparation and Processing Procedures on the Thermal Diffusivity of MgO‐C Refractories

open access: yesAdvanced Engineering Materials, EarlyView.
The thermal diffusivity of MgO‐C refractories is highly sensitive to sample preparation and processing procedures. In this article, the effects of coking sequence, machining conditions, structural inhomogeneity, and graphite coating application on measurements using laser flash apparatus are systematically investigated.
Luyao Pan   +4 more
wiley   +1 more source

Determining clogging threshold of ceramic emitters to promote wolfberry production in Northwest China

open access: yesAgricultural Water Management
Drip irrigation is a worldwide water-saving irrigation technology and benefits crop production. Yet, the emitter clogging is still a crucial problem for application.
Xuanyue Tong   +3 more
doaj   +1 more source

CONCENTRATION OF SINGLE SUPERPHOSPHATE ON CLOGGING OF DRIP EMITTERS

open access: yesIRRIGA, 2018
CONCENTRATION OF SINGLE SUPERPHOSPHATE ON CLOGGING OF DRIP EMITTERS     DAYANE RODRIGUES GONÇALVES1; PEDRO RÓBINSON FERNANDES DE MEDEIROS1; ELTON CARLOS PEREIRA VIEIRA DE ALENCAR TELES1; GABIANE SOUZA DOS SANTOS1; ROBERTO CASTRO NASCIMENTO1 E FRANCISCO MAX FERNANDES DO NASCIMENTO2   1Colegiado de Pós Graduação em ...
Francisco Max Fernandes   +5 more
openaire   +2 more sources

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

open access: yesAdvanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti   +11 more
wiley   +1 more source

Optimized selection of clean nitrogen fertilizers for high-sediment water pressure-compensating drip irrigation systems based on system failure perspective

open access: yesAgricultural Water Management
High-sediment water pressure-compensating drip irrigation (PCDI) has become a widely adopted technique for perennial crops, such as mountain fruit trees, in response to agricultural irrigation water shortages.
Changjian Ma   +7 more
doaj   +1 more source

An Investigation of Emitters Clogging Under Magnetic Field and Water Quality

open access: yesمجله آب و خاک, 2016
Introduction: Water scarcity is one of the major problems for crop production. Using drip irrigation as an effective method in the efficient use of water is expanding in arid and semi-arid regions.
A. Kiani   +3 more
doaj   +1 more source

Tribological Performance of 60NiTi Alloy Under Varying Contact Conditions and Elevated Temperatures in Linear Reciprocating Sliding

open access: yesAdvanced Engineering Materials, EarlyView.
This study investigates the tribological response of 60NiTi alloy under dry, water‐lubricated and high‐temperature conditions. The alloy exhibits decreasing wear volume and friction with increasing temperature due to the formation of protective oxide layers. The work clarifies dominant wear mechanisms and demonstrates the suitability of 60NiTi for high‐
Anthony Onyebuchi Okoani   +2 more
wiley   +1 more source

Home - About - Disclaimer - Privacy