Results 11 to 20 of about 1,001,066 (299)
Structural design of multi-body heave wave energy conversion system and analysis of energy efficiency of floating body on water surface [PDF]
Mechanical Sciences, 2022 Due to the defects of the internal structure and energy supply carrier, conventional deep sea unoccupied marine equipment cannot meet the requirements of low power consumption.
D. Cong +6 more
doaj +1 more source
CuInSe2 nanotube arrays for efficient solar energy conversion [PDF]
Scientific Reports, 2019 AbstractHighly uniform and vertically aligned p-type CuInSe2 (CISe) nanotube arrays were fabricated through a unique protocol, incorporating confined electrodeposition on lithographically patterned nanoelectrodes. This protocol can be readily adapted to fabricate nanotube arrays of other photoabsorber and functional materials with precisely ...
Wipula Priya Rasika Liyanage +1 more
openaire +2 more sources
Heat absorption properties of ground material for solar chimney power plants [PDF]
, 2016 One of the major challenges to the widespread application of the solar chimney power plant is its low-power conversion efficiency because of the three technological processes involved.
Al-Azawiey, S. S., Hassan, S. B.
core +1 more source
Technical limits for energy conversion efficiency [PDF]
Energy, 2020 To reach climate targets, unprecedented levels of energy efficiency improvements are required. To prioritise investments, it is necessary to know the energy saving potential associated with each action. Understanding the potential of technical improvements, requires knowledge on the highest technically achievable efficiency of a technology – the ...
Leonardo Paoli, Jonathan Cullen
openaire +2 more sources
Nihon Kikai Gakkai ronbunshu, 2021 Since plants with a high biomass conversion efficiency of light energy consume less energy and require shorter cultivation periods, it is expected that plant factories can have more output with less energy.
Ryota YORIFUJI, Shin’ya OBARA
doaj +1 more source
Exceeding the solar cell Shockley-Queisser limit via thermal up-conversion of low-energy photons [PDF]
, 2013 Maximum efficiency of ideal single-junction photovoltaic (PV) cells is limited to 33% (for one sun illumination) by intrinsic losses such as band edge thermalization, radiative recombination, and inability to absorb below-bandgap photons.
Boriskina, Svetlana V., Chen, Gang
core +2 more sources
Energy conversion efficiency of electrical exploding foil accelerators
AIP Advances, 2021 We evaluate the energy conversion efficiency of an electrical exploding foil accelerator that accelerates a thin dielectric foil (called the flyer) to more than 1 km/s, which is propelled by electrically exploded bridge material. The effective flyer mass
D. Ichihara +3 more
doaj +1 more source
Research status of replacement gases for SF6 in power industry
AIP Advances, 2020 SF6 is widely used in the industrial field due to its stable structure and excellent properties. It is mainly used in electrical insulation equipment. Due to the boiling point of SF6, its use in extremely cold regions has been limited.
Shuangshuang Tian +7 more
doaj +1 more source
Energy Conversion Efficiency of the Bulk Photovoltaic Effect
PRX Energy, 2023 The bulk photovoltaic effect (BPVE) leads to directed photocurrents and photovoltages in bulk materials. Unlike photovoltages in p-n junction solar cells that are limited by carrier recombination to values below the band-gap energy of the absorbing ...
Andreas Pusch +3 more
doaj +1 more source
Frontiers in Energy Research, 2021 The energy efficiency analysis is a prerequisite for the construction of the integrated energy system (IES). In this study, a novel energy efficiency analysis method is proposed considering different energy subsystems in the IES.
Shihai Yang +6 more
doaj +1 more source