Results 81 to 90 of about 227,287 (266)
Rapidly Solidified High‐Strength Invar 36 Prepared by Planar‐Flow Melt Spinning
Advanced Engineering Materials, EarlyView.The Invar 36 alloy was rapidly solidified using the planar‐flow melt‐spinning technique. Ribbon samples with thicknesses ranging from 20 to 160 mm were produced. As the grain size of the ribbon decreased to sub‐micron levels, the hardness increased by more than 2 times.
Bekir Akgül, Mehmet Kul
wiley +1 more source
A Novel Approach to Estimate the Transition Temperature via Dynamic Nanoindentation
Advanced Engineering Materials, EarlyView.A new dynamic nanoindentation‐based method was developed that uses the stiffness ratio as an indicator of the elastic–plastic deformation contributions at different temperatures. The approach successfully identified transition temperatures in ferritic steel and distinguished them from continuously ductile austenitic steel.
Stefan Zeiler +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This perspective reframes additive manufacturing for electrical machines as a qualification‐limited materials and architecture design problem. It links process–structure–property–performance relationships to magnetic, conducting, dielectric, and thermal property windows, highlighting where AM can enable segmented magnetic circuits, permanent magnet ...
Dénes Fodor, Loránd Szabó
wiley +1 more source
南方能源建设[Introduction] Since the initiation of China's "reform and opening up" policy in 1978, Guangdong Province has achieved significant progress in economic growth and energy sector development.
Dongqi WU +4 more
doaj +1 more source
Spatial Data Starter Kit for OnSSET Energy Planning in Kitui County, Kenya. [PDF]
Data Brief, 2022 Mwendwa DM +9 more
europepmc +1 more source
Elastic–Plastic Modeling and Experimental Characterization of Granular Jamming Actuators
Advanced Engineering Materials, EarlyView.Granular jamming enables rapid switching between soft and rigid mechanical states. Here, a reduced‐order elastic‐perfectly‐plastic beam framework captures pressure‐dependent loading, unloading, residual deformation, and hysteresis in jammed beams, while matching three‐point bending experiments across materials and geometries. The framework links design
Saheli Patel +2 more
wiley +1 more source
The Goal of Carbon Peaking, Carbon Emissions, and the Economic Effects of China's Energy Planning Policy: Analysis Using a CGE Model. [PDF]
Int J Environ Res Public Health, 2022 Hu H, Dong W.
europepmc +1 more source
Energy planning with decision-making tools: experiences from an energy-planning project
Local Environment, 2009 This article presents the evaluation of a pilot project where four decision-making tools are applied in a municipal energy planning process in a Swedish municipality.
openaire +3 more sources
Advanced Engineering Materials, EarlyView.Additive manufacturing introduces pronounced microstructural and crystallographic anisotropy in Ni‐based superalloys, resulting in orientation‐dependent creep deformation and damage. This review identifies the key microstructural origins of creep anisotropy, examines their influence on dominant deformation mechanisms, and highlights processing ...
Chandan Kumar +3 more
wiley +1 more source
Sustainable energy planning for the aspiration to transition from fossil energy to renewable energy in Northern Cyprus. [PDF]
Heliyon, 2022 Akçaba S, Eminer F.
europepmc +1 more source