Results 1 to 10 of about 187,453 (121)
Energy Regeneration Hydraulic System via a Relief Valve with Energy Regeneration Unit [PDF]
Applied Sciences, 2017 Relief valves are widely used in industrial machinery. Due to the outlet of the relief valve being connected to the tank, the pressure drop of the relief valve is frequently equal to the inlet pressure. Accordingly, the energy loss of the relief valve is
Tianliang Lin +6 more
doaj +2 more sources
Ultrasonics Sonochemistry, 2021 Activated alumina used in dehumidification should be regenerated at more than 110 °C temperature, resulting in excessive energy consumption. Comparative experiments were conducted to study the feasibility and performance of ultrasonic assisted ...
Xinzhu Mou, Zhenqian Chen
doaj +1 more source
Reducing energy costs during solvent regeneration at the tar deasphalting unit
Proceedings of the Voronezh State University of Engineering Technologies, 2021 For propane tar deasphalting units, a rather high energy intensity of the technological process is characteristic. In order to reduce it, an assessment was made of the possibility of reducing the steam consumption during the regeneration of propane from asphalt solution.
A. V. Myasoedov +2 more
openaire +2 more sources
南方能源建设, 2021 [Introduction] The double-turbine regeneration system can improve the energy efficiency of the unit. How to design the control strategy and ensure its safety, economy and effectiveness has been the prime focus of our group.
LIN Kan +3 more
doaj +1 more source
Heliyon, 2021 Refinery plants use diethanolamine (DEA) solutions for gas sweetening. The role of DEA is to absorb H2S from sour gas. Amine Regeneration Units (ARU) are used to regenerate the rich Amine with H2S from refinery units to Lean Amine.
Ahmed Y. Ibrahim +2 more
doaj +1 more source
Efficiency analysis of sorption-enhanced method in steam methane reforming process
Carbon Resources Conversion, 2023 The sorption-enhanced method can change the thermodynamic equilibrium by absorbing CO2. However, it also brings about the problems of high regeneration temperature of adsorbent and large regeneration energy consumption.
Yaowei Hu +6 more
doaj +1 more source
Case Studies in Chemical and Environmental Engineering, 2023 Aqueous ammonia can be used as a solvent in post-combustion carbon capture (PCC) instead of commercial solvents, which are mainly fossil based (e.g. MEA, DEA).
Fernando Zea +2 more
doaj +1 more source
Formulation Study of N-Aminoethyl Piperazine and Sodium Glycine CO2 Absorbent
发电技术, 2023 Chemical absorption method is one of the most widely used technologies to capture CO2 from flue gas of coal-fired power plants, but it has problems of low absorption capacity and high regeneration energy consumption.
WANG Li, ZHANG Huan, YE Yi, ZHAO Xinglei
doaj +1 more source
Study the Performance of a Novel Desiccant Heat Exchanger [PDF]
Engineering and Technology Journal, 2023 Conserving energy and reducing emissions has become a global consensus. However, most air conditioning systems are highly energy-consuming, affecting global warming and the ozone layer because they use chlorine and fluorine refrigerating fluids ...
Hind Taresh +2 more
doaj +1 more source
Optimization of chemical regeneration procedures of spent activated carbon [PDF]
Advances in Environmental Technology, 2017 The chemical regeneration of granular activated carbon exhausted in a petrochemical wastewater unit was investigated. Gas chromatography and energy-dispersive X-ray spectroscopy demonstrated that spent activated carbon carries large types of organic and ...
Naser Ghasemzadeh +2 more
doaj +1 more source