Results 31 to 40 of about 294,557 (311)

Melting of PCM in a thermal energy storage unit: Numerical investigation and effect of nanoparticle enhancement [PDF]

open access: yes, 2012
The present paper describes the analysis of the melting process in a single vertical shell-and-tube latent heat thermal energy storage (LHTES), unit and it is directed at understanding the thermal performance of the system.
Sciacovelli, Adriano   +3 more
core   +1 more source

Multifunctional sandwich composites containing embedded lithium-ion polymer batteries under bending loads

open access: yesMaterials & Design, 2020
Multifunctional composites that combine high load-bearing properties and energy storage capacity have potential application in next-generation electric vehicles. The effect of high structural bending loads on the flexural properties and electrical energy
J. Galos, A.S. Best, A.P. Mouritz
doaj   +1 more source

High-Temperature Energy Storage Properties of Bi0.5Na0.5TiO3-0.06BaTiO3 Thin Films

open access: yesCrystals, 2023
Bi0.5Na0.5TiO3-0.06BaTiO3 (BNT-BT) thin films were prepared via both chemical solution (CSD) and pulsed laser deposition (PLD). The structural, dielectric, and ferroelectric properties were investigated.
Ilham Hamdi Alaoui   +5 more
doaj   +1 more source

2D materials for 1D electrochemical energy storage devices [PDF]

open access: yes, 2019
One-dimensional (1D) electrochemical energy storage devices, such as fiber supercapacitors and cable-shaped batteries, are promising energy storage solutions for emerging wearable electronics due to their advantages in flexibility, weavability, and ...
Xuncai Chen   +17 more
core   +1 more source

A novel lead-free Na0.5Bi0.5TiO3-based ceramic with superior comprehensive energy storage and discharge properties for dielectric capacitor applications

open access: yesJournal of Materiomics, 2020
Na0.5Bi0.5TiO3 (NBT)-based ceramics have been widely used as dielectric materials for energy storage capacitors because of their environmental friendliness and excellent ferroelectric properties.
Da Li   +5 more
doaj   +1 more source

Enhanced energy storage properties of amorphous BiFeO3/Al2O3 multilayers

open access: yesJournal of Materials Research and Technology, 2021
The energy storage density of ferroelectric thin film capacitors is mainly limited by the breakdown strength. Here we demonstrate that the high breakdown strength and high energy storage density can be achieved by constructing BiFeO3/Al2O3 ...
Ze Li   +8 more
doaj   +1 more source

Experimental and theoretical investigation of an innovative composite nanofluid for solar energy photothermal conversion and storage [PDF]

open access: yes, 2022
Molten salts play a key role in the heat transfer and thermal energy storage processes of concentrated solar power plants. A novel composite material was prepared in this work by adding micron-sized magnesium particles into Li2CO3-Na2CO3-K2CO3 molten ...
Ding, J.,   +4 more
core   +1 more source

Microstructure and dielectric properties of sub-micron hollow sphere (Ba(0.6)Sr(0.4))TiO(3)/PVDF composites

open access: yesIET Nanodielectrics, 2019
Hollow sphere (Ba(0.6)Sr(0.4))TiO(3) (HS-BST) powders with sub-micron size and different shell thickness were synthesised through template-assisted method. HS-BST/poly(vinylidene fluoride) (PVDF) composites were prepared using tape casting method.
Yiting Guo   +8 more
doaj   +1 more source

Review on microencapsulated phase change materials (MEPCMs) : fabrication, characterization and applications [PDF]

open access: yes, 2011
The use of latent heat storage, microencapsulated phase change materials (MEPCMs), is one of the most efficient ways of storing thermal energy and it has received a growing attention in the past decade.
Zhao, Changying   +3 more
core   +1 more source

Effect of sintering temperature on the dielectric, ferroelectric and energy storage properties of SnO2-doped Bi0.5(Na0.8K0.2)0.5TiO3 lead-free ceramics [PDF]

open access: yesJournal of Advanced Dielectrics, 2020
Sintered lead-free Bi0.5(Na0.8K0.2)0.5(Ti0.96Sn0.04)O3 ceramics (BNKTS) have been fabricated via a solid-state reaction. The effect of sintering temperature on the structural, morphological, dielectric, ferroelectric and energy storage properties of ...
Nguyen Truong-Tho, Le Dai Vuong
doaj   +1 more source

Home - About - Disclaimer - Privacy