Results 51 to 60 of about 1,758,407 (277)
Advanced Materials Technologies, EarlyView.Parallel wiring of bioelectrochemical devices with conventional generators unexpectedly boosts output. A biophotovoltaic paired with a solar cell delivers up to 50% more power at low loads than their separate contributions; a plant microbial fuel cell shows similar current gains.
Valeria Marsaglia +4 more
wiley +1 more source
Autonomous Locomotion of Tensegrity Structure on Low‐Temperature Surfaces
Advanced Robotics Research, EarlyView.A low‐temperature responsive tensegrity structure (LRTS) is constructed by integrating low‐responsive temperature liquid crystal elastomer (LCE) cables, nonresponsive cables, and stiff rods. The low phase transition temperature of LCE is achieved by introducing a new liquid crystal mesogen.
Changyue Liu +5 more
wiley +1 more source
Fire resistance evaluation of rice husk ash concrete
Heliyon, 2018 This paper studied the fire resistance of rice husk ash concrete. An experimental method was adopted as the research design in this work, which produced one hundred and eighty four (184) concrete specimens with the addition of rice husk ash in weighted ...
R.I. Umasabor, J.O. Okovido
doaj +1 more source
PLANNING AND PROGRAMMING FIRE SAFETY DEFICIENCY CORRECTION PROJECTS COMPLIANCE WITH THIS PUBLICATION IS MANDATORY [PDF]
ACCESSIBILITY: Publications and forms are available for downloading or ordering on the e-Publishing website at www.e-Publishing.af.mil. RELEASABILITY: There are no releasability restrictions on this publication.
Civil Engineering
core
Innovative learning at The University of Edinburgh [PDF]
, 2014 The activities available to civil engineering students during the University of Edinburgh's innovative learning week in 2012 were examined. The academic staff proposed a wide range of possible activities and student participation was optional.
Alison Furber +12 more
core +1 more source
3D‐Printing Aided Rapid Prototyping of Pretensioned Tensegrity Structures for Robotic Applications
Advanced Robotics Research, EarlyView.Printing, injection molding, and assembly (PMA) is a method for rapid prototyping mesoscale, topologically complex, and tensioned tensegrity structures. In combination with PMA method, two mold design strategies: modular mold and compact channel layout, enable efficiency and scalability for tensegrity fabrication.
Yi Sun +3 more
wiley +1 more source
Dinamika Rekayasa, 2017 Hot Rolled Sheet (HRS) merupakan campuran aspal yang menggunakan gradasi senjang dengan kandungan agregat kasar, agregat halus dan memiliki kandungan aspal yang tinggi sehingga dibutuhkan mutu campuran beraspal yang baik untuk menghasilkan perkerasan ...
Anita Rahmawati
doaj +1 more source
A Survey Study Of Supplier Selection Issues In Construction Supply Chain [PDF]
It is undeniable fact that construction industry is a very important product of Gross Domestic Product (GDP) of our country. It is almost 11 % of the GDP of our country. It is the second most employment providing sector after agriculture. In spite of its
Civil Engineering Dept
core
Promoting academic excellence amongst the engineering students [PDF]
, 2006 This paper describes activities carried out by the College of Engineering at Universiti Tenaga Nasional (UNITEN) in order to promote academic excellence amongst the engineering students and to enhance their academic standings.
Hasan, Zaimah +5 more
core
Industrial work placement in higher education: a study of civil engineering student engagement [PDF]
, 2018 For civil engineering undergraduates, the opportunity to spend a period of time in formal industrial work placement provides an invaluable learning experience.
Archer W +30 more
core +6 more sources