Results 1 to 10 of about 75,598 (105)
Intelligent Petroleum Engineering
Engineering, 2022 Data-driven approaches and artificial intelligence (AI) algorithms are promising enough to be relied on even more than physics-based methods; their main feed is data which is the fundamental element of each phenomenon.
Mohammad Ali Mirza +2 more
doaj +1 more source
Study of the processes of the purification of water from surface sources from petroleum products [PDF]
E3S Web of Conferences, 2021 Recently, the amount of natural waters contaminated with petroleum products, which enter surface sources together with wastewater, has increased. Therefore, the issues of natural water purification of petroleum products are given great importance ...
Busarev Andrey +2 more
doaj +1 more source
آموزش مهندسی ایران, 2014 In this research, petroleum engineering education in Bachelor of Science level (BSc) and research areas of petroleum engineering faculty of different universities in Asia and Australia have been investigated and then it has been compared with Iranian ...
Mohammad Azaditabar, Abbas Hashemizadeh
doaj +1 more source
BOOK REVIEW "PETROLEUM PRODUCTION ENGINEERING"
Rudarsko-geološko-naftni Zbornik, 2016 Here is given the review of the book „Petroleum Production Engineering“ written by Marin Čikeš, Ph. D., a retired Full Professor of the Faculty of Mining, Geology and Petroleum Engineering of the University of Zagreb.
Sonja Koščak Kolin
doaj +1 more source
Could petroleum work as lubricant oil on slippery lubricated surfaces to prevent inorganic scaling?
Heliyon, 2020 The use of nucleation and growth inhibitors at offshore oil industry to avoid inorganic scaling could be replaced by both physical and chemical modifications at surfaces to prevent the scaling.
Filipe Signorelli +1 more
doaj +1 more source
Heliyon, 2019 In the present investigation raw oil (jatropha, soybean, and waste cooking fuel) has analyzed to prove its suitability as an alternative fuel in compression ignition (CI) engines.
Prem Kumar Chaurasiya +3 more
doaj +1 more source
Heliyon, 2019 Langmuir isotherm is the most common adsorption model used in the prediction of gas adsorption in most shale and coal bed methane reservoirs. However, due to the underlying assumption of single temperature, it fails to model gas adsorption where ...
John Fianu +2 more
doaj +1 more source
Heliyon, 2019 Modern-day climate and environmental factors are largely responsible for the different geometric characteristics exhibited by formation zones/petroleum reservoirs which makes them highly selective with respect to their adaptation to drilling fluids ...
Emeka Emmanuel Okoro +4 more
doaj +1 more source
A bibliometric analysis of the application of machine learning methods in the petroleum industry
Results in Engineering, 2023 With the emerge of Artificial Intelligence and Machin learning systems, the petroleum industry has witnessed a significant progress in its different disciplines to optimize decision making, time and costs.
Zahra Sadeqi-Arani, Ali Kadkhodaie
doaj +1 more source
Fuels with low octane number: water injection as knock control method
Heliyon, 2019 The present paper deals with the study of water effect on the combustion of fuels with low Octane Number in Internal Combustion Engines. In particular, this study was carried out using a variable volumetric compression ratio CFR fuel engine.ASTM ...
S. Brusca +4 more
doaj +1 more source