Results 191 to 200 of about 3,885,664 (293)

Fabrication Routes for Ionic Conducting Fiber Strain Sensors

open access: yesAdvanced Engineering Materials, EarlyView.
Ionic conducting fiber strain sensors (ICFSs) offer compliant, textile‐integrable sensing. Thus far, the commercialization of ICFSs has been constrained by fiber fabrication routes. This review provides a fabrication‐centric analysis of ICFSs correlating processing strategies with material properties and scalability.
Leo John Kershaw   +3 more
wiley   +1 more source

Determinants of Compliance to Enhanced Recovery Protocol After Emergency Laparotomy. [PDF]

open access: yesWorld J Surg
Ceresoli M   +18 more
europepmc   +1 more source

Gallium Microalloying in Bi–Sn Solders: Interfacial Phase Formation, Wettability, and Long‐Term Shear Reliability Under Isothermal Aging

open access: yesAdvanced Engineering Materials, EarlyView.
Gallium microalloying redirects interfacial reactions in low‐temperature Bi–Sn solders from Cu–Sn toward Cu–Ga intermetallic formation. The resulting Cu–Ga layer suppresses intermetallic growth during thermal aging, alters fracture pathways, and improves interfacial stability.
Iva Králová   +6 more
wiley   +1 more source

Investigating the Low‐Temperature Phase Stability of the Binary Ta–W System

open access: yesAdvanced Engineering Materials, EarlyView.
Atomistic simulations show that the binary Ta–W system forms ordered intermetallic phases, B2‐TaW and D03‐TaW3, as 0 K ground states. Configurational entropy, however, lowers the free energy of the disordered bcc solid solution, which becomes the stable phase above about 400 K.
Klemens Lechner   +7 more
wiley   +1 more source

Enhanced Recovery After Surgery in Pediatric Urology Patients Undergoing Complex Lower Urinary Tract Reconstruction.

open access: yesJAMA Surg
Rove KO   +21 more
europepmc   +1 more source

A Novel Approach to Estimate the Transition Temperature via Dynamic Nanoindentation

open access: yesAdvanced Engineering Materials, EarlyView.
A new dynamic nanoindentation‐based method was developed that uses the stiffness ratio as an indicator of the elastic–plastic deformation contributions at different temperatures. The approach successfully identified transition temperatures in ferritic steel and distinguished them from continuously ductile austenitic steel.
Stefan Zeiler   +4 more
wiley   +1 more source

Home - About - Disclaimer - Privacy