Results 11 to 20 of about 5,487,142 (143)
Spectral emittance measurements for ytterbium disilicate‐based environmental barrier coatings
International Journal of Ceramic Engineering & ScienceThe spectral reflectance and transmittance of two free‐standing ytterbium disilicate (Yb2Si2O7)—based environmental barrier coatings (EBCs) were measured from 25°C up to 1270°C.
Michael J. Presby +3 more
doaj +2 more sources
Engineering design of feedstock powder and relevant thermal–mechanical performance of thermal/environmental barrier coatings [PDF]
Journal of Advanced CeramicsThe development of aeroengine with a high thrust-weight ratio poses great challenges for current top-coating thermal barrier coatings (TBCs) and environmental barrier coatings (EBCs) in service. Medium/high-entropy ceramics are highly promising candidate
Xinchang Feng +10 more
doaj +2 more sources
Degradation of Environmental Protection Coatings for Gas Turbine Materials [PDF]
, 2008 Nowadays, problems of component materials reliability in gas and oil-fired gas turbines focus on assessing the potential behaviour of commonly employed coatings, in order to avoid expensive and unpredictable failure in service and producing new materials
Nalin, Laura
core +7 more sources
, 2023 In recent years, with the development of SiC composites in aero-engine hot-end components, environmental barrier coatings (EBCs) have received extensive attention.
Weize Wang +3 more
core +1 more source
, 2023 Ceramic matrix composites with environmental barrier coatings (CMC/EBCs) are the most promising material solution for hot section components of aero-engines.
Guangwu Fang, Xiguang Gao, Yingdong Song
core +1 more source
Environmental barrier coatings for silicon nitride
, 2022 S.139-144Ytterbium silicate layers were deposited on Si3N4 ceramics as environmental barrier coatings (EBCs) by a dip coating-sintering method.
Chen, H., Klemm, H.
core +2 more sources
Reinforced sol–gel thermal barrier coatings and their cyclic oxidation life [PDF]
, 2013 Cyclic oxidation life enhancement of sol–gel thermal barrier coatings is obtained via the reinforcement of the controlled micro-crack network that forms during the initial sintering of the deposit.
Ansart, Florence +5 more
core +1 more source
A Review of the Erosion of Thermal Barrier Coatings. [PDF]
, 2007 The application of thermal barrier coatings (TBCs) to components with internal cooling in the hot gas stream of gas turbine engines has facilitated a steep increase in the turbine entry temperature and the associated increase in performance and ...
Wellman, R. G., Nicholls, John R.
core +1 more source
Implementation of in Process Surface Metrology for R2R Flexible PV Barrier Films [PDF]
, 2015 Thin functional barrier layers of aluminum oxide (Al2O3) that are used particularly in photovoltaic (PV) modules to prevent the possibility of water vapor ingress should be applied over the entire PV surface without any defects.
Gao, F. +5 more
core +4 more sources
Cailiao gongchengWith the development of aero-engine technology， the rising operating temperature makes the service environment of environmental barrier coatings （EBCs） increasingly severe， imposing higher demands on their comprehensive performance.
WANG Longhui, LIU Rongjun, WANG Yanfei
doaj +1 more source