Results 81 to 90 of about 1,181,868 (194)
Small, Volume 22, Issue 51, 11 September 2026.Using synchrotron‐based multiscale imaging, generative modeling algorithms, and computational mechanics models, our study reveals a scale‐dependent transition in bone mechanics. The results of the power‐scaling law illustrate a transition from density‐controlled stiffness at the trabecular scale to connectivity‐controlled, porosity‐sensitive mechanics ...
Milad Masrouri +3 more
wiley +1 more source
Restoration Ecology, Volume 34, Issue 7, September 2026.Abstract Introduction Coral populations have declined in recent decades, largely due to anthropogenic climate change. In response, coral restoration projects are being implemented, and rubble stabilization is one such approach. Rubble beds form when dead coral fragments accumulate on the seafloor and can be mobilized by water flow.
Kyle M. Phillips +2 more
wiley +1 more source
Concrete rehabilitation using epoxy resins
, 2010 The use of polymeric materials in civil construction makes possible original bonding processes because they have good adhesion. In this paper the bond between fresh/hardened concrete was made using epoxy resins in aqueous solution. Also the incorporation of one filler in the epoxy resins was analyzed. This study had two phases.
Silva, Luís, Aguiar, J. L. Barroso de
openaire +1 more source
Experimental Study on the Characteristics of Polymer Concrete With Epoxy Resin
Bulletin of the Polytechnic Institute of Jassy: Constructions, Architechture Section, 2008 In the paper are presented the results of some experimental researches concerning polymer mortars and concretes realized of epoxy resin, silica fume and crushed aggregates. The mechanical characteristics of hardened concrete were determined. The silica fume content varied between 6.5% and 30% to polymer mortar and 6.4% and 9.6% to polymer concrete. The
Bărbuţă, Marinela +1 more
openaire +2 more sources
Polymer Composites, Volume 47, Issue 16, Page 14313-14338, 20 August 2026.PSPP‐TRL mapping of CNT‐modified CFRP literature, with four recurring confusions resolved and five scale‐up problems quantified. ABSTRACT Carbon nanotube‐modified fiber composites are often presented as a route to stronger, tougher, and self‐sensing structural materials.
Sanan H. Khan
wiley +1 more source
Prestressed textile reinforced concrete with carbon composite reinforcement
Acta Polytechnica CTU ProceedingsThe article deals with the potential of prestressed textile concrete. The prestressing principle, which is nowadays commonly used part of construction, is combined with the developing technology of textile concrete which is concrete reinforced with non ...
Jan Macháček +4 more
doaj +1 more source
Case Studies in Construction MaterialsThis study investigates the impact of long-term and short-term loading on the flexural behavior of reinforced concrete (RC) beams strengthened using the near surface mounted (NSM) method.
Sima Rostami Aghouy +2 more
doaj +1 more source
Case Studies in Construction MaterialsRoller-compacted concrete (RCC) is a common material in Road pavements. It has many advantages, but repairing and maintaining it can be challenging. Self-healing can offer a suitable solution.
Amir Salimi +2 more
doaj +1 more source
Insights into the properties of pervious concrete modified with polymers and fine aggregate
Case Studies in Construction MaterialsPervious concrete is increasingly being utilized in urban road construction; however, its low strength and durability limit its broader applications. This study explores the use of fine aggregate and polymers to enhance the strength and durability of ...
Yang Wang +4 more
doaj +1 more source
Performance of optimized composition of epoxy resin adhesive used in High Friction Surface Treatment
Case Studies in Construction MaterialsThe High Friction Surface Treatment (HFST) paving technique is widely employed in engineering practices globally, serving to enhance the long-term anti-skid performance of pavements.
Jiapeng Li +5 more
doaj +1 more source