Results 41 to 50 of about 23,308 (300)
Phase separation and mechanical properties of epoxy / thermoplastic blends [PDF]
, 2003 Thermosetting epoxy resins blended with aromatic thermoplastics are of significant commercial interest in several areas including aerospace, transportation and electronics.
Emmerson, Gordon T., Emmerson, Gordon T
core
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Isotopically enriched crosslinked epoxy polymers [PDF]
, 1994 The epoxy resin system based on tetraglycidyldiaminodiphenyl- methane (TGDDM) and diaminodiphenylsulfone (DDS) is widely used for high performance aerospace applications.
White, Jeffrey Robert
core
Effects of catalysts and post-curing conditions in the polymer network of epoxy and phenolic resins: preliminary results [PDF]
, 2008 In the earlier study about polymer network of phenolic and epoxies resins mixed with linseed oil, only Phencat 15 was used as the catalyst for the phenolic resin.
Ku, H. +3 more
core +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Applied Sciences, 2023 To improve the thermal and mechanical properties of epoxy resins, epoxy-functionalized POSS (E-POSS) and glass fiber (GF) were used to reinforce epoxy resin (E51) composites.
Jianliang Jiang +4 more
doaj +1 more source
Cure modelling and monitoring of epoxy/amine resin systems [PDF]
, 1998 Thermoanalytical techniques and dielectric analysis were used in this study to describe and characterise the cure processes occurring during the isothermal and dynamic cures of four epoxy/amine resin systems.
Karkanas, Panagiotis I., Karkanas, P.I.
core
Speed and Temperature Effects in the Energy Absorption of Axially Crushed Composite Tubes
, 2008 Tubes of glass reinforced thermosetting resins have been tested in axial compression between steel platens with one end chamfered to prevent critically high loads causing catastrophic centre failure.
core +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Recent progress in degradation and recycling of epoxy resin
Journal of Materials Research and TechnologyEpoxy resin is widely used in electrical equipment and electronic devices fields due to its excellent electrical, thermal, and mechanical properties.
Yu Feng +10 more
doaj +1 more source