Results 171 to 180 of about 1,271,490 (330)
Advanced Engineering Materials, EarlyView.Primary phases and a fatigue crack are studied in a forged blank of an aluminum alloy using synchrotron and laboratory X‐ray computed tomography. To image the crack, the fatigue test is interrupted, and a static tensile load is applied to open the crack.
Jakob Schröder +6 more
wiley +1 more source
Reliability Evaluation and Improvement of Islanded Microgrid Considering Operation Failures of Power Electronic Equipment [PDF]
, 2020 Wen Zhong +3 more
openalex +1 more source
Advanced Engineering Materials, EarlyView.In this research, ZrC coatings are evaluated against various counterprobes at the microscale using novel super‐stiff atomic force microscopy cantilevers. The chemical composition of the coating is shown to be an important factor influencing coating hardness and Young's modulus, while surface roughness, counterprobe hardness, and surface energy are the ...
Piotr Jenczyk +4 more
wiley +1 more source
Modeling time to failure using a temporal sequence of events [PDF]
arXivIn recent years, the requirement for real-time understanding of machine behavior has become an important objective in industrial sectors to reduce the cost of unscheduled downtime and to maximize production with expected quality. The vast majority of high-end machines are equipped with a number of sensors that can record event logs over time.
arxiv
Advanced Engineering Materials, EarlyView.Laboratory protocols for producing thin‐film pH electrodes for sterilized single‐use technologies have been successfully developed into a semiautomated workflow, with higher throughput and precision of membrane thickness. Accuracies are within 0.05 pH units versus ground truth, and uncertainty analysis reveals the largest sources of error to be derived
Bingyuan Zhao +4 more
wiley +1 more source
Equipment failure of intravenous syringe pump detected by increase in Narcotrend stage: A case report. [PDF]
Medicine (Baltimore), 2018 Niu K, Guo C, Han C, Teng S.
europepmc +1 more source
TCR remote monitoring for the LHC technical infrastructure [PDF]
, 2003 The remote monitoring of the LHC technical infrastructure will mainly be done in CERN’s Technical Control Room (TCR). The technical infrastrucure consists of specialised equipment from different groups and divisions, mainly cooling and ventilation and ...
Blanc, D +3 more
core
Advanced Engineering Materials, EarlyView.Ni‐base superalloys produced using additive manufacturing (AM) have a different response to heat treatments when compared to their conventional counterparts. Due to such unpredictability, various alloys with industrial interest are currently overlooked in most prior AM research.
Guilherme Maziero Volpato +6 more
wiley +1 more source