Results 71 to 80 of about 3,154,972 (231)
Postbuild annealing systematically modifies the phase fractions and morphology of EB‐PBF processed Mo–9Si–8B. Quantitative microstructure–property correlations reveal how controlled phase evolution enhances high‐temperature compressive strength and creep resistance.
Christopher Schmidt +5 more
wiley +1 more source
ITC/USA 2010 Conference Proceedings / The Forty-Sixth Annual International Telemetering Conference and Technical Exhibition / October 25-28, 2010 / Town and Country Resort & Convention Center, San Diego, CaliforniaCurrent failure analysis practices use ...
Losik, Len
core +2 more sources
Sustainability assessment requires methodologies that appropriately distinguish between additive and non‐additive material properties. A toxicity‐weighted scoring system is developed and applied that accounts for the disproportionate influence of highly toxic constituents through nonlinear weighting functions, providing more realistic estimates than ...
Seth Mehalic +2 more
wiley +1 more source
A Novel Approach to Estimate the Transition Temperature via Dynamic Nanoindentation
A new dynamic nanoindentation‐based method was developed that uses the stiffness ratio as an indicator of the elastic–plastic deformation contributions at different temperatures. The approach successfully identified transition temperatures in ferritic steel and distinguished them from continuously ductile austenitic steel.
Stefan Zeiler +4 more
wiley +1 more source
Machine Anomalous Sound Detection Method Based on Lightweight Temporal Pyramid and ECA-MobileFaceNet
To address the challenges of scarce anomaly samples, inadequate modeling of temporal dynamic features, and limited feature selection capability of lightweight models in industrial anomalous sound detection, this paper proposes a method under an ...
Yuezhou Wu +3 more
doaj +1 more source
Microstructural evolution of premium rail steel during flash butt welding (FBW), comparing physically simulated heat‐affected zones with actual weld regions. Thermal cycles induce phase transformations and microstructural heterogeneity that influence weld quality and mechanical performance. These findings provide insights into optimizing FBW parameters
Emmanoelle Cintra da Cunha Araújo +15 more
wiley +1 more source
Static Rate of Failed Equipment-Related Fatal Accidents in General Aviation
General aviation (GA), comprised mainly of piston engine airplanes, has an inferior safety history compared with air carriers in the United States. Most studies addressing this safety disparity has focused on pilot deficiencies. Herein, we determined the
Douglas D. Boyd, Linfeng Jin
doaj +1 more source
Study on Computer Aided Failure Analysis System of Chemical Equipment
Objective: To study the failure analysis system by means of chemical equipment computer. Methods: To test and detect the failure of parts of chemical equipment, then determine the form of failure, find out the main cause of failure, and study the related
Tianfeng Li
doaj +1 more source
Particle morphology controls the balance between printability and electrical connectivity in low‐temperature AgCu/Ag metallization pastes. Flake‐shaped AgCu particles form extended low‐resistance contacts, whereas spherical particles favor processability at high metal loading. Fine Ag particles further tune void filling and conductive‐network formation
O. Mhirsi +3 more
wiley +1 more source
Although traditional fault diagnosis methods can qualitatively identify the failure modes for power equipment, it is difficult to evaluate the failure probability quantitatively. In this paper, a failure probability calculation method for power equipment
Hang Liu +5 more
doaj +1 more source

