Results 151 to 160 of about 532,480 (294)
Advanced Functional Materials, EarlyView.An efficient NiOx HTL is successfully prepared by introducing MXene as an additive without further surface modification to fabricate high‐performance FASn0.5Pb0.5I3 perovskite solar cells. The introduction of MXene contributes to improved conductivity of NiOx, better aligned at NiOx/perovskite interfaces, and enhanced quality of perovskite films ...
Lijun Chen +12 more
wiley +1 more source
Advanced Functional Materials, EarlyView.Bio‐based bionic spider silk and spider web are first prepared using polyelectrolyte complexation technique for the simultaneous harvesting of water and triboelectric energy. The advantage of this process lies on entirely bio‐based materials, fully green water‐processable procedures, extremely high production rate (99.36%), excellent fog harvesting ...
Qin Chen +9 more
wiley +1 more source
A New Procedure Based on Continuous RTU Measurement to Estimate Multi-port Thevenin Equivalent Circuit Parameters of an External Power System [PDF]
Iranian Journal of Electrical and Electronic EngineeringIn this paper, a novel method is presented that can accurately estimate the Thevenin equivalent circuit parameters of an external power system by RTUs. The presented method is based on the simultaneous measurements of the desired points in the boundary ...
Nabiollah Ramezani +1 more
doaj
Advanced Functional Materials, EarlyView.Dual‐cation site engineering unlocks stable and fast sodium storage in Na4VMn(PO4)3 cathodes. Li+ at Na2 suppresses Jahn‐Teller distortion, while K+ at Na1 expands ion channels, enabling synchronized V/Mn redox and quasi‐single‐phase kinetics. This atomic‐level strategy achieves ultralong cycling stability, high‐rate capability, and full cell viability
Jiaze Sun +8 more
wiley +1 more source
Permeability and Equivalent Circuit Model of Ionically Conductive Mortar Using Electrochemical Workstation. [PDF]
Materials (Basel), 2020 Xu A, Weng Y, Zhao R.
europepmc +1 more source
Advanced Functional Materials, EarlyView.Inspired by the skin‐toughening mechanism of marine sponges, an ion‐orchestrated structural engineering strategy is proposed to regulate the surface microstructure of hydrogel coatings, enabling the in situ formation of a robust armor layer that enhances mechanical integrity and provides multifunctional protection by suppressing fouling attachment and ...
Wenshuai Yang +11 more
wiley +1 more source
Broadband Lumped-Element Parameter Extraction Method of Two-Port 3D MEMS In-Chip Solenoid Inductors Based on a Physics-Based Equivalent Circuit Model. [PDF]
Micromachines (Basel), 2020 Sun J +6 more
europepmc +1 more source
An evaluation of corrosion protection by two epoxy primers on 2219-T87 and 7075-T73 aluminum [PDF]
A comparison of the corrosion protection provided by two amine epoxy primers was made using salt fog, alternate immersion, and total immersion as exposure media. The study is the result of a request to use an unqualified low volatile organic carbon (VOC)
Mendrek, M. J.
core +1 more source
Advanced Functional Materials, EarlyView.PTFE nanoparticle–anchored rGO (rGO@PTFE) for scalable solvent‐free fabrication of ultra‐thick, high‐density cathodes, achieving high conductivity (9.55 S cm−1), lithium transference (0.73), and improved wettability, is developed. The resulting cathode delivers 15.2 mAh cm−2 areal and 563 mAh cm−3 volumetric capacities, with full cells exhibiting 637 ...
Juhee Yoon +7 more
wiley +1 more source
Advanced Functional Materials, EarlyView.Rational halogen mixing strategy was employed to shift the bandgap of Cs2PbBr2I2 from ultraviolet to visible region, enabling first realization of a visible‐light photodetector with this 2D layered Ruddlesden‐Popper perovskite material. Under illumination, light‐induced internal field forms and drives trap‐mediated persistent photoconductivity ...
Md Fahim Al Fattah +11 more
wiley +1 more source