Results 141 to 150 of about 1,066,022 (300)
Advanced Materials Interfaces, EarlyView.Interfacial charge transfer and low‐resistance interphase formation between PEO‐based polymer and Li10GeP2S12 solid electrolytes are investigated using multi‐electrode impedance spectroscopy and advanced analytical techniques such as XPS and ToF‐SIMS.
Ujjawal Sigar +6 more
wiley +1 more source
Iranian Journal of Electrical and Electronic Engineering, 2012 This paper presents an approach to calculate the equivalent stray capacitance (SC) of n-turn of the helical flux compression generator (HFCG) coil with multi layer conductor wire filaments (MLCWF) in the form of rectangular cross-section.
M. E. Mosleh, M. R. Besmi
doaj
Analysis and Improvement of Wired Equivalent Privacy Protocol
Review of Computer Engineering Studies, 2019 Zhiyong Luo +3 more
openaire +2 more sources
Photocatalytic Water Splitting on the Lunar Surface: Prospects for In Situ Resource Utilization
Advanced Materials Interfaces, EarlyView.Water has been found in craters on the moon nearby locations which are illuminated >80% of the time. Photocatalysis uses energy from sunlight to drive chemical reactions such as water splitting to produce oxygen and hydrogen. It is a scalable technology that requires lighter equipment and utilizes resources available on the moon. ABSTRACT The discovery
Ranjani Kalyan +6 more
wiley +1 more source
, 1920 The steamer Clifford F. Hood of the American Steel & Wire Company, a subsidiary of U. S. Steel, at the Central Furnaces and Docks in Cleveland, Ohio, ca. 1920-1935.
American Steel & Wire Company
core
Advanced Materials Interfaces, EarlyView.Ba‐doped SrTiO3 perovskites establish a direct correlation between photoelectrochemical activity and photocatalytic performance. Optimized Ba0.5Sr0.5TiO3 exhibits enhanced charge separation, photocurrent generation, and visible‐light‐driven dye degradation through defect‐induced oxygen vacancies and lattice distortion.
Sagar A. Nikam +6 more
wiley +1 more source
Advanced Materials Interfaces, EarlyView.A 4‐layer Kevlar‐based composite is fabricated by combining ultrasonic spraying and electrostatic flocking. Carbon black dispersion is first deposited onto Kevlar fabric to create a conductive electrode. Nylon fibers are then electrostatically flocked onto the coated fabric, forming a dielectric layer.
Mengdi Chen +7 more
wiley +1 more source
Skin‐Like Tri‐Modal Sensors Based on Soft Piezoelectric and Ionic Composites
Advanced Materials Technologies, EarlyView.Inspired by the multimodal perception of human skin, a soft, skin‐like tri‐modal sensor is presented. The device incorporates an ionically conductive, piezoelectric, elastic composite as its active layer, enabling independent detection of temperature, static strain, and dynamic strain within a single two‐terminal architecture.
Liren Wang +9 more
wiley +1 more source
Nature‐Derived Chitosan Biopolymer: A Promising Candidate for Sustainable Electronics
Advanced Materials Technologies, EarlyView.In the creation of environmentally friendly devices, nature‐derived chitosan biopolymer is a promising contender for sustainable electronic research. It can be utilized to create more ecologically friendly scalable gadgets and has a variety of uses in different active layers of electronics.
Joshua McDonald +3 more
wiley +1 more source
Физика волновых процессов и радиотехнические системы, 2017 The article considers the construction of mathematical models of vibrator antennas with a large cross-section on the basis of thin-wire integral representations of the electromagnetic field.
D.P. Tabakov, S.V. Morozov, V.A. Neganov
doaj