Results 11 to 20 of about 31,453 (270)

Cladding-pumped erbium-doped multicore fiber amplifier

open access: yesOptics Express, 2012
A cladding pumped multicore erbium-doped fiber amplifier for simultaneous amplification of 6 channels is demonstrated. Peak gain over 32 dB has been obtained at a wavelength of 1560 nm and the bandwidth measured at 20-dB gain was about 35 nm. Numerical modeling of cladding pumped multicore erbium-doped amplifier was also performed to study the ...
K S, Abedin   +9 more
openaire   +4 more sources

Q-switched fiber laser employing a passive polarization-maintaining thulium-doped fiber as a saturable absorber

open access: yesResults in Physics, 2022
We present the application of polarization-maintaining thulium-doped fiber (PM-TDF) as a saturable absorber in an erbium-ytterbium-doped fiber laser.
A.W. Al-Alimi   +6 more
doaj   +1 more source

Extremely Efficient DFB Lasers with Flat-Top Intra-Cavity Power Distribution in Highly Erbium-Doped Fibers

open access: yesSensors, 2023
High-performance erbium-doped DFB fiber lasers are presently required for several sensing applications, whilst the current efficiency record is only a few percent.
Amirhossein Tehranchi, Raman Kashyap
doaj   +1 more source

Comparison of 1480 nm and 980 nm-pumped Gallium-Erbium fiber amplifier [version 2; peer review: 1 approved, 2 approved with reservations]

open access: yesF1000Research, 2021
Background: One way to reduce the length of the gain medium in Erbium-Doped Fiber Amplifier (EDFA) is by doping the fiber core with a high concentration of Erbium.
Tuan Ainin Sofea Tuan Mohd Marzuki   +4 more
doaj   +1 more source

Femtosecond Pulsed Fiber Laser Based on Graphdiyne-Modified Tapered Fiber

open access: yesNanomaterials, 2022
We report the application of saturable absorbers prepared from graphdiyne-modified tapered fibers to an erbium-doped fiber laser to achieve a femtosecond pulse output. Graphdiyne quantum dots are successfully prepared by the Glaser–Hay method.
Qing Wu, Si Chen, Wenli Bao, Haibin Wu
doaj   +1 more source

Ultrafast L Band Soliton Pulse Generation in Erbium-Doped Fiber Laser Based on Graphene Oxide Saturable Absorber

open access: yesCrystals, 2023
We demonstrate a simple mode-locked Erbium-doped fiber laser (EDFL) based on self-synthesized saturable absorber (SA) by combining graphene oxide (GO) and polyethylene oxide (PEO) solutions to form a GO-PEO thin film. This thin film was incorporated into
Hazlihan Haris   +9 more
doaj   +1 more source

Inhomogeneous Gain Saturation in EDF: Experiment and Modeling [PDF]

open access: yes, 2011
Erbium-Doped Fiber Amplifiers can present holes in spectral gain in Wavelength Division Multiplexing operation. The origin of this inhomogeneous saturation behavior is still a subject of controversy.
Boivin, David   +4 more
core   +3 more sources

Design of Radiation-Hardened Rare-Earth Doped Amplifiers Through a Coupled Experiment/Simulation Approach [PDF]

open access: yes, 2013
We present an approach coupling a limited experimental number of tests with numerical simulations regarding the design of radiation-hardened (RH) rare earth (RE)-doped fiber amplifiers.
Boscaino, Roberto   +15 more
core   +4 more sources

Experimental Investigation of pump propagating direction in double-pass Er3+-doped fiber amplifiers [PDF]

open access: yes, 2005
In this paper, the impacts of pump propagating direction in double-pass Erbium-doped fiber amplifier are experimentally demonstrated. The double-pass optical amplifier architecture is constructed using a fiber loop mirror that consists of a circulator to
Al-Mansoori, Mohammed Hayder   +4 more
core   +2 more sources

Erbium-implanted high-Q silica toroidal microcavity laser on a silicon chip [PDF]

open access: yes, 2004
Lasing from an erbium-doped high-Q silica toroidal microcavity coupled to a tapered optical fiber is demonstrated and analyzed. Average erbium ion concentrations were in the range 0.009–0.09 at.
Kalkman, Jeroen   +5 more
core   +1 more source

Home - About - Disclaimer - Privacy