Results 221 to 230 of about 197,708 (266)

Enhanced Switching Performance in Single‐Crystalline PbTiO3 Ferroelectric Memristors for Replicating Synaptic Plasticity

open access: yesAdvanced Functional Materials, EarlyView.
This study demonstrated single‐crystalline PbTiO3‐based memristors with atomically sharp interfaces, well‐ordered lattices, and minimal lattice mismatch. The devices exhibited an ON/OFF ratio exceeding 105, high stability, and rich resistance‐state modulation.
Haining Li   +7 more
wiley   +1 more source

Error Correction in Bluetooth Low Energy via Neural Network with Reject Option. [PDF]

open access: yesSensors (Basel)
Almeida WD   +3 more
europepmc   +1 more source

CO2 Reduction on Copper‐Nitrogen‐Doped Carbon Catalysts Tuned by Pulsed Potential Electrolysis: Effect of Pulse Potential

open access: yesAdvanced Functional Materials, EarlyView.
This study demonstrates that pulsed potential electrolysis significantly improves CO2 reduction performance on copper‐nitrogen doped carbon electrodes. The formation of cationic copper sites and metallic clusters as a function of applied intermittent potential leads to notable selectivity changes compared to potentiostatic reduction.
Dorottya Hursán   +13 more
wiley   +1 more source

2D Phosphorene‐Decorated Ni‐Rich Layered Cathodes for High‐Power and High‐Energy Li‐Ion Batteries

open access: yesAdvanced Functional Materials, EarlyView.
A conformal coating of 2D phosphorene nanosheets is decorated on Li[Ni0.8Co0.1Mn0.1]O2 cathodes to enhance fast charge–discharge performance and structural stability under high mass loading and low carbon content. As a result, it exhibits improved power capability, cycle stability, and suppressed structural degradation, offering a promising strategy ...
Jihoe Lee   +15 more
wiley   +1 more source

Boosting the Energy Density of “Anode‐Free” Lithium Metal Batteries via Electrospun Polymeric Scaffolds

open access: yesAdvanced Functional Materials, EarlyView.
While host structures are known to enhance the reversibility and safety of lithium metal deposition, their additional volume and weight often decrease the battery's energy density and specific energy. By combining a lightweight and porous scaffold of electrospun polymer with a thinner separator, this article demonstrates a simultaneous improvement of ...
Lennart Wichmann   +6 more
wiley   +1 more source

Decoupling Size and Electronic Effects in Doped SrTiO3 Photocatalysts Through Surface Area–Normalized CO2 Hydrogenation Rates

open access: yesAdvanced Functional Materials, EarlyView.
Exploring the photocatalytic reverse water–gas shift (RWGS) reaction on doped SrTiO3 nanoparticle films, reveals that normalizing catalytic rates by the catalyst's specific surface area (SSA) disentangled surface area effects from the catalyst's intrinsic material properties.
Dikshita Bhattacharyya   +6 more
wiley   +1 more source

Correction to "Self-Tuning Reaction Conditioning of a Paper-Based Electrochemical Biosensor for Acetaldehyde Detection". [PDF]

open access: yesACS Omega
Sari SR   +8 more
europepmc   +1 more source

Home - About - Disclaimer - Privacy