Results 191 to 200 of about 65,673 (237)

MXene‐Coated 3D Printed Horn Antennas for Ku Frequency Band

open access: yesAdvanced Materials Technologies, EarlyView.
An additive manufacturing approach to 3D printing horn antennas and coating them with Ti3C2Tx MXene is proposed. Rapid fabrication of lightweight, high‐performance antennas operating in the Ku‐band (12.4–18 GHz) has been demonstrated. The MXene‐coated antennas exhibit comparable electromagnetic performance to conventional, costly aluminum ones, with ...
Zahra Sarpanah Sourkouhi   +3 more
wiley   +1 more source

Printed Organic Thermoelectric Generators: Progress and Challenges Towards Efficient Energy Harvesting

open access: yesAdvanced Materials Technologies, EarlyView.
Printed organic thermoelectric generators (OTEGs) enable flexible and sustainable energy harvesting from low‐grade heat. This Perspective critically assesses recent advances in printable thermoelectric materials, 2D and 3D device architectures, and current performance limits of printed OTEGs.
Vijitha Ignatious   +5 more
wiley   +1 more source

TADF‐Emitting Dendrimers for Scalable Bar‐Coating Fabrication of Light‐Emitting Electrochemical Cells

open access: yesAdvanced Materials Technologies, EarlyView.
TADF‐emitting dendrimers promise to enable scalable solution‐based fabrication of efficient electroluminescent devices by the virtue of an attractive set of properties. Here, we report on how light‐emitting electrochemical cells, comprising the TADF‐dendrimer tBuCz2m2pTRZ, can be fabricated by scalable bar‐coating under ambient air and deliver uniform ...
Shi Tang   +5 more
wiley   +1 more source

Development of Heat Engines Powered by Twisted and Coiled Polymer Fiber Actuators

open access: yesAdvanced Materials Technologies, EarlyView.
Continuously rotating engines driven by thermally responsive actuating materials can turn waste heat into useful energy. For the first time heat engines operated by twisted and coiled polymer fiber actuators are demonstrated with engine design guided by two simple analytical models.
Geoffrey M. Spinks   +2 more
wiley   +1 more source

Additive Manufacturing of Ni‐Based Thermoelectric Materials for Waste Heat Recovery

open access: yesAdvanced Materials Technologies, EarlyView.
Thermoelectric generators convert waste heat into electricity but are constrained by conventional fabrication. Here, laser powder bed fusion enables direct printing of customised n‐type Cu60Ni40 and p‐type Ni90Cr10 legs. The assembled module achieves 0.8% efficiency at ΔT = 419 K, demonstrating scalable additive manufacturing of eco‐friendly, design ...
Karolin Amstein   +6 more
wiley   +1 more source

Home - About - Disclaimer - Privacy