Results 201 to 210 of about 2,273,648 (354)

Design and Prototyping of Topology‐Optimized, Additively Manufactured Lightweight Components for Space Robotic Systems: A Case Study

Advanced Engineering Materials, EarlyView.
The results demonstrate a simulation‐driven workflow that applies LSB topology optimization with additive manufacturing constraints to mission‐specific load cases, integrating European Cooperation for Space Standardization compliant verification and manufacturability to develop structurally efficient rover suspension components.
Stelios K. Georgantzinos, Grigorios Kostopoulos, Eleni Papadopoulou, Stefanos Voulgaris, Alexandra Tseni, Panteleimon Bakalis, Maria N. Gkara, Chara Ch. Mitropoulou, Georgios Kazakis, Alin Munteanu, Jeremi Gancet, Nikos D. Lagaros   +11 more
wiley   +1 more source

Globalisation, European Integration and Social Protection – Patterns of Change or Continuity?

, 2007
Olaf van Vliet, Michael Kaeding
openalex   +1 more source

Distribution of Electrical Resistivity in Single Carbon Fiber Filaments and Its Correlation With Tensile Modulus

Advanced Engineering Materials, EarlyView.
A statistical framework is applied to quantify the distribution of electrical resistivity among individual filaments of two commercially available carbon fiber types. Correlations between filament resistivity, tensile modulus, and diameter are examined and complemented by TEM analysis to provide new insight into filament‐level variability relevant for ...
Nils Wieja, Daniel Sebastian Wolz, Philip Johannes Steinbild, Markus Löffler, Darius Pohl, Jan Wolf, Anja Winkler, Thomas Behnisch, Bernd Rellinghaus, Maik Gude   +9 more
wiley   +1 more source

Population of Nonmetallic Inclusions in Liquid High‐Silicon Electrical Steel in Contact With MgO–C Refractories Based on Recyclates and Environmentally Friendly Binders

Advanced Engineering Materials, EarlyView.
The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert, Matheus Roberto Bellé, Florian Kerber, Dinesh Kumar Gunasekar, Hans‐Jörn Weddige, Christos G. Aneziris, Olena Volkova   +6 more
wiley   +1 more source

European Courts as Value-Harmonizing 'Motors of Integration'

, 2014
Josef Bejček
openalex   +1 more source

Engineering Deformation and Failure in Diamond Triply Periodic Minimal Surface Lattices via 3D Wall‐Thickness Grading

Advanced Engineering Materials, EarlyView.
The work demonstrates that strategic wall‐thickness grading in diamond triply periodic minimal surface lattices enables precise tuning of deformation and failure behavior under compression. Different gradation patterns guide how and where the structure collapses, improving energy absorption or promoting controlled brittle failure.
Giovanni Rizza, Danilo Bruson, Manuela Galati, Luca Iuliano   +3 more
wiley   +1 more source

Integrating Intermittent Renewable Wind Generation - A Stochastic Multi-Market Electricity Model for the European Electricity Market [PDF]

, 2015
Jan Abrell, Friedrich Kunz
openalex   +1 more source