Results 31 to 40 of about 62,161 (331)
Three-Phase Planar Eutectic Growth Models for a Ternary Eutectic System
In order to consider a phase selection in a ternary eutectic system, analytical expressions for three-phase planar eutectic growth have been derived, assuming the geometries as regular, rod+hexagon and semi-regular types. Irrespective of geometries the relations that the undercooling is proportional to the square root of the growth rate of the ...
Toshiaki Himemiya, Takateru Umeda
openaire +2 more sources
Effect of the Al2O3 content on the microstructure evolution of flash-sintered Al2O3–8YSZ ceramics
Systematic explorations of complex insulator–conductor composites may help in better comprehending the nature of flash sintering. In this study, flash sintering of alumina–8 mol% yttria stabilized zirconia (Al2O3–8YSZ) binary system with different mixing
Shu Yao +4 more
doaj +1 more source
Novel cost-effective Fe-based high entropy alloys with balanced strength and ductility
Based on the current pseudo-binary design strategy of eutectic high entropy alloy (EHEA), a novel approach to design eutectic or near-eutectic HEA was proposed. The eutectic composition can be experimentally specified through adjusting the atomic content
Yu Yin +6 more
doaj +1 more source
Growth of Self Organized Eutectic Fibers from LiF-Rare Earth Fluoride Systems
Eutectic fibers consisting of an ordered arrangement of LiF fibrils inside a LiREF4 matrix (RE = Y, Gd) can be grown with the micro-pulling-down method at sufficiently large pulling rate exceeding 120 mm/h.
Acosta, Maria F. +5 more
core +1 more source
Solidification Morphology Analysis of SLM of Cu Powder [PDF]
The solidification morphology analysis of fine Cu powder melted by a raster scanned energy beam from a focused Nd:YAG laser is presented here. The powder was processed inside of sealed chamber where it was subjected to a high vacuum cycle.
Bourell, David L., Ramos Grez, Jorge A.
core +1 more source
Deep eutectic solvents (DES), compared to classic ones, have interesting properties, such as the ability to solubilize compounds differing in polarity or increased dissolution of selected chemical compounds.
Danuta Raj
doaj +1 more source
Pattern Selection in the Eutectic Growth – Thermodynamic Interpretation [PDF]
The (Zn) – single crystal strengthened by the E = (Zn) + Zn16Ti eutectic precipitate is subjected to directional growth by the Bridgman’s system and current analysis.
W. Wołczyński
doaj +1 more source
Influence of interphase anisotropy on lamellar eutectic growth patterns
It is well documented in many experiments that crystallographic effects play an important role in the generation of two-phase patterns during the solidification of eutectic alloys. In particular, in lamellar composites, large patches of perfectly aligned
Ghosh, Supriyo, Plapp, Mathis
core +1 more source
Novel inorganic binary mixture for low‐temperature heat storage applications [PDF]
In this study, an inorganic mixture based on bischofite (industrial by‐product) was developed and characterized for its application as a phase change material for low‐temperature thermal energy storage. The most appropriate composition was established as
Cabeza, Luisa F. +3 more
core +2 more sources
Procedure of calculation of three- and four-component eutectic system temperature and composition on the basis of two-component systems known characteristics and the initial substances known melting-points is introduced.
Olga S Afanasieva, Galina F Egorova
doaj +3 more sources

