Experimental study of the effects of secondary air on the emissions and stability of a lean premixed combustor [PDF]
Tests were run using a perforated plate flameholder with a relatively short attached recirculation zone and a vee gutter flameholder with a relatively long attached recirculation zone.
Raman, R. S. V., Roffe, G.
core +1 more source
Verification and Comparison of Nine Exhaust Gas Recirculation Mass Flow Rate Estimation Methods. [PDF]
Sensors (Basel), 2020 Nyerges Á, Zöldy M.
europepmc +1 more source
Techniques utilized in the simulated altitude testing of a 2D-CD vectoring and reversing nozzle [PDF]
Simulated altitude testing of a two-dimensional, convergent-divergent, thrust vectoring and reversing exhaust nozzle was accomplished. An important objective of this test was to develop test hardware and techniques to properly operate a vectoring and ...
Block, H. Bruce +6 more
core +1 more source
A Comparison of Inlet Valve Operating Strategies in a Single-Cylinder Spark-Ignition Engine [PDF]
, 2009 This experimental work was concerned with comparison of inlet valve actuation strategies in a thermodynamic single cylinder spark ignition research engine equipped with a mechanical fully variable valvetrain on both the inlet and exhaust.
Aleiferis, PG +3 more
core
Combined Effects of a Biobutanol/Ethanol-Gasoline (E10) Blend and Exhaust Gas Recirculation on Performance and Pollutant Emissions. [PDF]
ACS Omega, 2020 Zhao L, Wang D.
europepmc +1 more source
, 2009 The transport sector is one of the major contributors to greenhouse gas emissions. This study investigated three greenhouse gases emitted from road transport: CO2, N2O and CH4 emissions as a function of engine warm up and driving cycles.
Andrews, GE +6 more
core
Prediction of the flow inside a micro gas turbine combustor [PDF]
, 2008 The main purpose of this study is to predict the flow dynamics inside a micro gas turbine combustor model. The flow field inside the combustor is controlled by the liner shape and size, wall side holes shape, size and arrangement (primary, secondary and
Eldrainy, Yehia A. +2 more
core
Improved components for engine fuel savings [PDF]
The Engine Component Improvement (ECI) Project formulated to address near term improvements for current engines is described with emphasis on the development of component technologies to reduce the fuel consumption of CF6, JT9D, and JT8D engines.
Antl, R. J., Mcaulay, J. E.
core +1 more source
The position of gas turbine power plants with respect to the emission of nitrogen oxides by fossil-fueled energy installations [PDF]
The amount of nitrogen oxides introduced into the atmosphere by gas turbines is very significant in relation to the total amount of nitrogen oxide emissions produced by chemical installations and combustion engines.
Kaiser, E.
core +1 more source
Gas turbine engine with recirculating bleed [PDF]
, 1978 Carbon monoxide and unburned hydrocarbon emissions in a gas turbine engine are reduced by bleeding hot air from the engine cycle and introducing it back into the engine upstream of the bleed location and upstream of the combustor inlet. As this hot inlet
Adamson, A. P.
core +1 more source