Results 51 to 60 of about 18,849 (193)
Dissimilar metal joining of stainless steel and titanium using copper as transition metal [PDF]
, 2016 Joining of stainless steel and titanium dissimilar metal combination has a specific interest in the nuclear industry. Due to the metallurgical incompatibility, it has been very difficult to produce reliable joints between these metals due to the ...
Ganguly, Supriyo +3 more
core +1 more source
MetalsIn this paper, the microstructure and mechanical properties at the interface of Incoloy825/X65 bimetallic composite pipe achieved by explosive welding were systematically studied. Results show that a periodic wavy bonding interface was formed between the
Yuwei Sun +5 more
doaj +1 more source
Journal of Manufacturing and Materials ProcessingMultilayer composite materials, consisting of layers of aluminum alloy and steel, are used in the manufacturing of large engineering structures, including in the shipbuilding and railcar industries.
Andrey Malakhov +5 more
doaj +1 more source
The Development of Penetration Charges for Increasing the Efficiency of the Interventions of Fire Rescue Service Units [PDF]
, 2019 During building fires is often necessary to deliver nozzles with water to the desired point of intervention and the wall or ceiling must be penetrated for energy supply and the entrance of persons.
Barčová, Karla +2 more
core +1 more source
Civilized explosive welding: Impact welding of thick aluminum to steel plates without explosives
Journal of Manufacturing Processes, 2018 Abstract In this paper, we report welding of 6.35 mm thick AA5052-H32 and AA1100-H14 plates to mild steel, which was achieved in a laboratory environment by vaporizing foil actuator welding (VFAW). An AA3003-H14 interlayer was used between the AA5052-H32 and the mild steel to improve weldability.
Taeseon Lee +4 more
openaire +2 more sources
, 1978 An electroexplosive device is presented which employs a header having contact pins hermetically sealed with glass passing through from a connector end of the header to a cavity filled with a shunt layer of a new nonlinear resistive composition and a heat-
Menichelli, V. J.
core +1 more source
MetalsThis study aims to examine how the collision angle affects the Cu-Ta weld generated by the explosive welding method using molecular dynamics modeling. When two blocks collide, the metallic substrates melt rapidly.
Van-Thuc Nguyen +5 more
doaj +1 more source
Application of laser in seam welding of dissimilar steel to aluminium joints for thick structural components [PDF]
, 2015 Laser welding-brazing technique, using a continuous wave (CW) fibre laser with 8000 W of maximum power, was applied in conduction mode to join 2 mm thick steel (XF350) to 6 mm thick aluminium (AA5083-H22), in a lap joint configuration with steel on the ...
Ganguly, Supriyo +4 more
core +1 more source
Ultrasound application when explosion welding
Science intensive technologies in mechanical engineering, 2017 A combined process of metal welding by means of an explosion with simultaneous an ultrasound impact upon metal pieces to be welded is considered. Basic regularities in the formation of metal joints during explosion welding with a simultaneous impact of ultrasonic oscillations are shown, and interconnections between parameters of the combined process ...
Evgeny Kuzmin +2 more
openaire +2 more sources
Explosive Welding of Tubular Configurated Joints for Critical Applications [PDF]
, 1985 Explosive welding can provide the answer to problems of permanently joining metals typically used in the aerospace industry. The explosive bonding process is a solid state bonding process enabling material incompatibility problems associated with fusion ...
Hardwick, R.
core +1 more source