Results 91 to 100 of about 89,179 (263)
Advanced Engineering Materials, EarlyView.In this experimental study, the mechanical properties of additively manufactured Ti‐6Al‐4V lattice structures of different geometries are characterized using compression, four point bending and fatigue testing. While TPMS designs show superior fatigue resistance, SplitP and Honeycomb lattice structures combine high stiffness and strength. The resulting
Klaus Burkart +3 more
wiley +1 more source
Rheocasting versus Die Casting: An Insight into the Low‐Cycle Fatigue Behavior of AlSi7Mg0.6
Advanced Engineering Materials, EarlyView.The study compares rheocast lightweight components with high‐pressure die cast materials regarding microstructure and fatigue behavior. Rheocast process offers higher efficiency due to lower casting temperatures. Despite some microstructural differences, both processes show similar strengths (yield strength 125 MPa, tensile strength 240 MPa).
Julia Richter +4 more
wiley +1 more source
Research in Sport Education and SciencesThis research is conducted to examine the academic procrastination behaviors of students studying at the faculty of sports sciences through the locus of control and academic attributional styles.
Ceyhun Alemdağ, Tuğba Mataracı
doaj +1 more source
Advanced Engineering Materials, EarlyView.The results demonstrate a simulation‐driven workflow that applies LSB topology optimization with additive manufacturing constraints to mission‐specific load cases, integrating European Cooperation for Space Standardization compliant verification and manufacturability to develop structurally efficient rover suspension components.
Stelios K. Georgantzinos +11 more
wiley +1 more source
Russian Journal of Education and PsychologyBackground.Modern medical education is associated with a high level of stress, which requires medical students to have well-developed adaptive resources.
Nina N. Vishnyakova +2 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé +5 more
wiley +1 more source
Research on Addiction, 2013 Aim: The purpose of this study was the study of relationship between religious attitudes, locus of control and tendency to substance abuse among students of Guilan University. Method: The research design was correlational design.
Farhad Asghari +2 more
doaj
Screen‐Printed Flexible Piezoelectric Force Sensor Array with Electromagnetic Interference Shielding
Advanced Engineering Materials, EarlyView.This article introduces a flexible screen‐printed piezoelectric sensor array designed for low‐frequency healthcare applications such as tactile sensing and cardiovascular monitoring. The device integrates interface electronics enabling the simultaneous acquisition of up to 128 signals, along with flexible EMI shielding that significantly reduces noise ...
Joseph Faudou +6 more
wiley +1 more source
روانشناسی بالینی و شخصیت, 2009 The main purpose of this research was investigating the effectiveness of enhancing optimism skills in the "locus of control" in high school students. This was an experimental study with pretest–posttest control group design.
F. Sohrabi, A. Javanbakhsh
doaj
Advanced Engineering Materials, EarlyView.The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert +6 more
wiley +1 more source