Results 61 to 70 of about 861 (153)

Technique of facial analysis with a new facebow transfer and CT-based anatomical modelling

, 2004
Technique of facial analysis with a new facebow transfer and CT-­‐based anatomical ...
BERTOSSI, Dario, BERTELE', Giampaolo, Vismara G, TREVISIOL, Lorenzo, NOCINI, Pier Francesco   +4 more
core   +1 more source

A digital approach to the evaluation of mandibular position by using a virtual articulator

, 2021
The purpose of this technique report was to describe a fully digital technique to evaluate the mandibular position both in centric relation occlusion (CRO) and maximal intercuspation position (MIP).
Kim, Jong Cheol, Lee, Kyung Min, Moon, Da Nal, Park, Mirinae, Park, Jae Hyun, Lee, Gye Hyeong   +5 more
core   +1 more source

Minimally Invasive Cantilever RBFPD Using a 270‐Degree Veneer Abutment in a Young Cleft Patient: A Clinical Adhesive Technique

Clinical Case Reports, Volume 14, Issue 5, May 2026.
ABSTRACT Adhesive cantilever resin‐bonded bridges (RBBs) are a minimally invasive option for replacing maxillary lateral incisors in young cleft patients, in whom implant placement is often delayed until completion of craniofacial growth or declined due to surgical burden. Beyond material selection, the outcome depends critically on abutment design and
Aspasia Pachiou, Aikaterini Maria Vraka, Panagiotis Andritsakis, Nikolaos Nikitas Giannakopoulos   +3 more
wiley   +1 more source

Rehabilitation Of Aesthetic Zone With Bopt And Digital Workflow

International Dental Journal
Introduction: This case report presents the rehabilitation of a patient with poor-quality maxillary prostheses and mandibular developmental defects of enamel (DDE).
Lingling Gong, Weiwei Xiao
doaj   +1 more source

Digital Removable Denture Workflows in Dental Education: A Systematic Review and Curriculum Development Exploration

European Journal of Dental Education, Volume 30, Issue 2, Page 547-560, May 2026.
ABSTRACT Background In the realm of dental education, the conventional methods of complete denture fabrication have long been the norm. However, these methods often struggle to effectively communicate complex techniques, leaving students lacking comprehensive hands‐on experiences.
Arthi Veerasamy, Fatimah Ghuloum, Yunam Lo, Wendy Jansen van Vuuren   +3 more
wiley   +1 more source

The Utility of Intraoral Scanning and a Modifiable Milled Trial Denture in Treating Complete Edentulism in a Patient With Special Care Needs: A Case Report

Special Care in Dentistry, Volume 46, Issue 3, May/June 2026.
ABSTRACT Introduction This case report documents the prosthodontic treatment of a 43‐year‐old male with special care needs who presented with a 13‐year history of complete edentulism and prosthodontic diagnostic index (PDI) type IV. The patient was unable to tolerate his previous dentures.
Joseph Curtis, Leonardo Marchini
wiley   +1 more source

Comparison of Sagittal Condylar Inclination and Bennett Angle Using Dynamic Jaw Motion Tracking System, Conventional Facebow Transfer, and a CBCT-Based Registration Method: A Single-Participant Pilot Feasibility Study

Applied Sciences
Accurate programming of sagittal condylar inclination (SCI) and Bennett angle (BA) is important for prosthodontic treatment, yet evidence directly comparing conventional and digital recording approaches remains limited.
Hwi Gyun Ahn, Keunbada Son, Kyu-Bok Lee
doaj   +1 more source

Prosthodontic Management of a Patient With a Combination of Hemimandibular Hyperplasia and Hemimandibular Elongation: A Clinical Report

Case Reports in Dentistry, Volume 2026, Issue 1, 2026.
Hemimandibular hyperplasia and hemimandibular elongation are two distinct forms of condylar hyperplasia that can present clinically with functional and esthetic disturbances. This case report describes prosthodontic treatment of a 59‐year‐old male patient diagnosed with hemimandibular hyperplasia and hemimandibular elongation.
Mohammed S. Murayshed, Sohil A. Kazim, Steven M. Morgano, Hannah Wesley   +3 more
wiley   +1 more source

A safety adaptation to Interlandi headgear.

, 1991
Extra-oral traction (E.O.T.) to a facebow is used with many types of removable, functional, and fixed orthodontic appliances. A versatile and popular method involves the elastic force being provided by an Interlandi headgear.
Hodgkins, J. F., Mossey, P. A., Williams, P.   +2 more
core   +1 more source

Complete Denture Rehabilitation Based On A Virtual Patient Model

International Dental Journal
Introduction: To present a digital workflow for complete denture fabrication using a virtual patient model, aimed at reducing clinical visits and improving accuracy.
Li Kai, Zhang Yan, Ai Lin, Wu Yulu
doaj   +1 more source