Results 1 to 10 of about 612 (161)

Testing of a Falling-Film Evaporator for Adsorption Chillers [PDF]

open access: yesEnergies, 2022
In this work, the performance of an innovative evaporator based on water falling film was investigated. The studied evaporator has been equipped with a recirculation system to maximise the wetted surface.
Tommaso Toppi   +4 more
doaj   +3 more sources

A Comparative Study of the Oil-Free Centrifugal Water Chillers with the Flooded or Falling Film Evaporator—A Case Study

open access: yesEnergies, 2019
A comparative study regarding the performance of real-scale oil-free centrifugal chillers having the flooded evaporator or falling film evaporator was conducted in this study.
Kuo-Shu Hung   +4 more
doaj   +3 more sources

Establishment of the falling film evaporation model and correlation of the overall heat transfer coefficient [PDF]

open access: yesRoyal Society Open Science, 2019
In order to study the heat transfer of the falling film evaporator with phase change on both sides, in this paper we built the mathematical model and the physical model where the liquid film inside the tube is laminar and turbulent. The film thickness of
Jing Fang, Kaixuan Li, Mengyu Diao
doaj   +1 more source

Experimental study on horizontal tube spray falling film evaporator in a low temperature geothermal binary cycle power system

open access: yesEnergy Reports, 2022
The horizontal tube spray falling film evaporator is an efficient evaporation equipment, which has the advantages of good heat exchange effect, small equipment volume and low cost.
Bing Hu   +3 more
doaj   +1 more source

Modelling of a falling-film evaporator for adsorption chillers

open access: yesInternational Journal of Refrigeration, 2023
The objective of the present study was to develop a dynamic model to simulate a prototype falling-film evap-orator that is part of a single-bed adsorption chiller test bench located at the Department of Energy of the Politecnico di Milano. The model is based on the evaporator energy and mass balances and was calibrated and validated using experimental ...
Aprile, M   +4 more
openaire   +1 more source

Numerical simulation analysis of heat and mass transfer of saline wastewater in a falling film evaporation tube based on different inlet modes

open access: yesWater Science and Technology, 2023
Falling film evaporation technology is widely used in the treatment of salt-containing wastewater in coal chemical industry. However, there is still a lack of research on the inlet method of vertical falling film evaporation tubes.
Xiang Cheng Kong   +7 more
doaj   +1 more source

Modeling of a falling film evaporator [PDF]

open access: yesLinköping Electronic Conference Proceedings, 2012
Falling film evaporators have demonstrated a good performance in air-conditioning and refrigeration. This paper presents the development of a detailed falling film evaporator model. The model is based on classical Newton’s viscosity law and Nusselt falling film theory.
Alberto de La Calle   +2 more
openaire   +1 more source

Experimental study of the flow dynamics and thermodynamic properties of a tube in vertical falling film evaporator for data center cabinets

open access: yesCase Studies in Thermal Engineering, 2023
This study presents an innovative integrated structure that combines a cabinet with a vertical falling film evaporator, enabling efficient natural evaporative cooling and effectively reducing energy loss in data centers.
Ganglin Cao   +7 more
doaj   +1 more source

Effect of cooling water flow on heat transfer performance of horizontal tube spray falling film evaporator in ORC system

open access: yesEnergy Reports, 2022
Organic Rankine cycle (ORC) uses low-temperature heat source to realize thermoelectric conversion, which is an important way to realize the effective recovery and utilization of waste heat.
Bing Hu, Jiajun Guo
doaj   +1 more source

Performances of Pentacene OFETs Deposited by Arbitrary Mounting Angle Vacuum Evaporator

open access: yesFrontiers in Materials, 2020
A vacuum evaporator is widely used for generating atomic/molecular beams for thin film deposition, and conventionally must be mounted to a vacuum chamber with an upwards angle from the horizontal.
Xueli Shen   +7 more
doaj   +1 more source

Home - About - Disclaimer - Privacy