Results 231 to 240 of about 1,595,600 (284)
Noise reduction for ventilation fans.
openaire +1 more source
Pareto-Driven Multiobjective Design of Axial-Flow Automotive Fan with Response Surface Modeling. [PDF]
Ren K +5 more
europepmc +1 more source
Towards precision oncology: unsupervised manifold learning for spatial molecular profiling in cancer tissues. [PDF]
Jiang G +6 more
europepmc +1 more source
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Journal of the American Society for Naval Engineers, 1953
Using the apparatus described by Reynolds, Wilson, and Beranek, measurements were made of the acoustic power in watts in twenty-four bands each one-third octave wide for three vaneaxial-type and two centrifugal-type fans of grades sizes. Formulas were derived empirically, enabling the computation of the over-all acoustic power of the noise for the ...
C. E. Peistrup, J. E. Wesler
+4 more sources
Using the apparatus described by Reynolds, Wilson, and Beranek, measurements were made of the acoustic power in watts in twenty-four bands each one-third octave wide for three vaneaxial-type and two centrifugal-type fans of grades sizes. Formulas were derived empirically, enabling the computation of the over-all acoustic power of the noise for the ...
C. E. Peistrup, J. E. Wesler
+4 more sources
Noise Notes, 2000
The cause of high noise generated by a table fan has been investigated. The noise source was identified by sound intensity mapping and frequency analysis of noise signal. The base of the fan stand was radiating high noise. The cause of this noise was found to be due to the resonance of fan stand.
openaire +1 more source
The cause of high noise generated by a table fan has been investigated. The noise source was identified by sound intensity mapping and frequency analysis of noise signal. The base of the fan stand was radiating high noise. The cause of this noise was found to be due to the resonance of fan stand.
openaire +1 more source
The Journal of the Acoustical Society of America, 1955
Extensions of earlier studies [J. Acoust. Soc. Am. 26, No. 2(1953)] on ventilation system noise are reported. It is shown here that in properly engineered ventilation systems the over-all sound power level in decibels re 1013a watt is related to the horsepower rating of the fan motor by the formula: PWL = 100+10 1og10hp.
Leo L. Beranek +2 more
openaire +1 more source
Extensions of earlier studies [J. Acoust. Soc. Am. 26, No. 2(1953)] on ventilation system noise are reported. It is shown here that in properly engineered ventilation systems the over-all sound power level in decibels re 1013a watt is related to the horsepower rating of the fan motor by the formula: PWL = 100+10 1og10hp.
Leo L. Beranek +2 more
openaire +1 more source
Journal of Sound and Vibration, 1971
Abstract Helicopter rotor noise theories are used to determine the noise of subsonic fans produced solely by the rotor, which results from aerodynamic intake flow distortions. Extensions to the theories allow for both stationary, phase-related distortions and distortions which vary randomly with time and may therefore be considered to rotate with ...
B. Barry, C.J. Moore
openaire +1 more source
Abstract Helicopter rotor noise theories are used to determine the noise of subsonic fans produced solely by the rotor, which results from aerodynamic intake flow distortions. Extensions to the theories allow for both stationary, phase-related distortions and distortions which vary randomly with time and may therefore be considered to rotate with ...
B. Barry, C.J. Moore
openaire +1 more source
Passive Noise Reduction for a Contra-Rotating Fan
Volume 1A: Aircraft Engine; Fans and Blowers, 2014There has been renewed interest in the contra-rotating (CR) fan configuration in aviation and other applications where size and weight are important design factors. Contra-rotation recovers swirl energy compared with the single-rotor design, but this advantage is not fully harnessed due to, perhaps, the issue of noise. This study explores passive noise
Wang, C, Huang, L
openaire +4 more sources
The Journal of the Acoustical Society of America, 1981
A fan for moving a gaseous fluid, e.g., air, is described in which the high audible frequency noise resulting from the phenomenon occurring at the trailing edges of the blades, known as vortex shedding, is reduced. This is accomplished by notching an edge of each of the blades so that the pattern of vortices leaving the blade, which causes the noise ...
openaire +1 more source
A fan for moving a gaseous fluid, e.g., air, is described in which the high audible frequency noise resulting from the phenomenon occurring at the trailing edges of the blades, known as vortex shedding, is reduced. This is accomplished by notching an edge of each of the blades so that the pattern of vortices leaving the blade, which causes the noise ...
openaire +1 more source
The Journal of the Acoustical Society of America, 1995
An axial flow fan includes blades mounted on a hub and extending radially outward to a shroud disposed around the hub. Pairs of stators are connected to the shroud at positions angularly spaced about the inner periphery of the shroud. Each pair of stators includes a trailing stator angularly spaced from a leading stator by a distance related to the ...
openaire +1 more source
An axial flow fan includes blades mounted on a hub and extending radially outward to a shroud disposed around the hub. Pairs of stators are connected to the shroud at positions angularly spaced about the inner periphery of the shroud. Each pair of stators includes a trailing stator angularly spaced from a leading stator by a distance related to the ...
openaire +1 more source

