Results 211 to 220 of about 14,460 (279)

Piezoresistive Natural Rubber Composites: A Comparison Between Low‐Temperature Glutaraldehyde Curing Agents and Conventional Sulfur Curing Systems

open access: yesPolymer Composites, EarlyView.
The secondary electrical signal peak during cyclic experiment observed in S‐cured NR sensors was eliminated with GA curing due to the homogeneous distribution of crosslink points in the GA‐cured NR network. ABSTRACT This study examines the piezoresistive behavior of natural rubber (NR) composites cured with sulfur (S) and glutaraldehyde (GA) and ...
Rawiporn Promsung   +5 more
wiley   +1 more source

Eco‐Friendly Bioplastic Film Produced With Green Plantain Starch (Musa paradisiaca L.): Effect of Activated Carbon Addition and Hydrothermal Modification

open access: yesPolymer Composites, EarlyView.
Activated Carbon as a Reinforcing Material for Starch Bioplastics. ABSTRACT Eco‐friendly starch‐based bioplastic films reinforced with activated carbon (AC) were produced using green plantain starch in its native and heat‐moisture treatment (HMT) forms to overcome typical limitations of starch materials, such as low mechanical strength and poor water ...
Eduardo Bruno Macêdo Viana   +8 more
wiley   +1 more source

Wide-field mid-infrared hyperspectral imaging beyond video rate. [PDF]

open access: yesNat Commun
Fang J   +6 more
europepmc   +1 more source

Optimization of Microfibrillated and Nanofibrillated Cellulose Coating to Improve Performance of Paperboard Intended for Food Packaging Applications

open access: yesPackaging Technology and Science, EarlyView.
This study aims to optimise the application methods of a biobased suspension of micro/nano cellulose fibrils from agro‐biomass subjected to high‐pressure homogenisation. Two methods were selected, bar coating (BC) and spray coating (SC), and were tested using an LF factorial design with 3 levels and 2 factors.
Andrea Feroce   +2 more
wiley   +1 more source

Thermodynamic and microphysical properties of summertime marine fog observed from Sable Island

open access: yesQuarterly Journal of the Royal Meteorological Society, EarlyView.
Atmospheric profiling and near‐surface fog and visibility measurements revealed synoptic‐scale forcing as the dominant factor in fog formation over Sable Island, with deep fog layers under low‐pressure systems and shallow fog layers under high‐pressure systems.
Kelsey Rowe   +7 more
wiley   +1 more source

Constructing Serrated Boride Composite Layer for Enhancing Wear Resistance of Ti6Al4V Alloy

open access: yesRare Metals, EarlyView.
ABSTRACT Appropriate configuration combined with strong interface bonding is the essential requirement for developing high wear‐resistant coatings. Herein, based on the powder‐pack boriding process, the properties of Ti6Al4V alloy are effectively improved by constructing a serrate tribological boride composite layer.
Ying Wu   +9 more
wiley   +1 more source

A High Capacity‐Long Cycling Concurrent Strategy of Ti3C2/MgH2 for Lithium Storage

open access: yesRare Metals, EarlyView.
ABSTRACT The excellent electrical conductivity and superior cycling stability render Ti3C2 MXene a promising Li ion battery anode. Nevertheless, the practical implementation of Ti3C2 MXene in commercial applications faces significant challenges, predominantly due to the low specific capacity.
Tingting Xu   +9 more
wiley   +1 more source

NIR‐Responsive Nano‐Integrated Magnesium Phosphate Cement Promotes Bone Regeneration via Osteoblast‐Exosome‐Osteoclast Crosstalk

open access: yesRare Metals, EarlyView.
ABSTRACT The limited osteogenic capacity of magnesium phosphate cement (MPC) has constrained its biomedical applications, underscoring the necessity to develop MPC with enhanced physical properties and bone‐forming capabilities. In this study, a multifunctional MPC system was developed by incorporating zoledronic acid‐loaded near‐infrared (NIR ...
Bin Wang   +8 more
wiley   +1 more source

Home - About - Disclaimer - Privacy