A new approach to model the fatigue anisotropy due to non-metallic inclusions in forged steels [PDF]
, 2012 The objective of this work is to propose an anisotropic fatigue criterion for the sizing of industrial forged components. The results from different experimental campaigns using three different rolled steels are first presented.
PESSARD, Etienne +3 more
core +1 more source
On the Tribocorrosion Behavior of Fe-Mn-Al-C Alloys in Ringer’s Solution
Metals, 2022 The long-term performance of steels is affected by the simultaneous actions of wear and corrosion, known as tribocorrosion. The tribocorrosion behavior of fully austenitic steels: Fe-Mn-xAl-C (x = 0, 3.5 and 8.3 wt.%) in Ringer’s solution was ...
Gisselle M. Barona-Osorio +3 more
doaj +1 more source
Estimation of the fatigue strength distribution in high-cycle multiaxial fatigue taking into account the stress–strain gradient effect [PDF]
, 2006 Based on the weakest link concept, a probabilistic approach in high-cycle multiaxial fatigue is developed to predict, for a given number of cycles, the probability distribution of the fatigue strength for metallic structural components. A three-parameter
DELAHAY, Thomas, PALIN-LUC, Thierry
core +1 more source
Early Relationships of a Low‐Energy Diet With Symptoms of Fibromyalgia
ACR Open Rheumatology, 2022 Objective Previous studies have demonstrated that weight loss has been shown to improve pain in weight‐bearing joints, and more recent studies suggest that weight loss may be accompanied by improvements in pain in non–weight‐bearing regions.
Aaron Stubbs +9 more
doaj +1 more source
High cycle fatigue damage mechanisms in cast aluminium subject to complex loads [PDF]
, 2013 Lien vers la version éditeur: http://www.sciencedirect.com/science/article/pii/S0142112312002356This article is dedicated to the high cycle fatigue behaviour of cast hypo-eutectic Al–Si alloys. In particular, the AlSi7Cu05Mg03 alloy is investigated.
AUGUSTINS, Louis +4 more
core +1 more source
Research Development on Bonded-bolted Hybrid Joint in Composite Structure
Hangkong gongcheng jinzhan, 2021 The composite bonded-bolted hybrid joint (BBHJ) is widely focused and developed in aerospace and aviation fields for its full consideration of advantages of bolt and bonded joint.
ZOU Peng +3 more
doaj +1 more source
Special Issue on ‘Multiaxial fatigue 2016: Experiments and modeling’: Selected papers from the 11th International Conference on Multiaxial Fatigue and Fracture (ICMFF11), held in Seville, Spain, on 1–3 June 2016 [PDF]
, 2017 This Special Issue of the International Journal of Fatigue contains selected papers presented at the International Conference on Multiaxial Fatigue and Fracture held in Seville, Spain, on 1–3 June ...
FATEMI, Ali +7 more
core +1 more source
The effect of weld residual stresses and their re-distribution with crack growth during fatigue under constant amplitude loading [PDF]
, 2010 In this work the evolution of the residual stresses in a MIG-welded 2024-T3 aluminium alloy M(T) specimen during in situ fatigue crack growth at constant load amplitude has been measured with neutron diffraction.
Lin, J. +18 more
core +1 more source
Journal of Natural Fibers, 2017 The chemical, physical and thermal properties of a new lignocellulosic fiber from Brazil (Imperata brasiliensis) were examined by SEM, chemical composition, XRD, FTIR, and TGA.
Kelly Cristina Coelho de Carvalho Benini +4 more
doaj +1 more source
Comparison between defects and micro-notches in multiaxial fatigue – The size effect and the gradient effect [PDF]
, 2009 Lien vers la version éditeur: http://www.sciencedirect.com/science/article/pii/S0142112308002156This paper attempts to improve the understanding of the multiaxial high cycle fatigue response of micro sized stress concentrations or notches of different ...
MOREL, Franck, NADOT, Yves, MOREL, Anne
core +1 more source