Results 161 to 170 of about 59,467 (314)
Appraising the suitability of a hybrid piston for internal combustion engines and its fatigue characteristics [PDF]
, 2012 This thesis was submitted for the degree of Master of Philosophy and awarded by Brunel University.Automotive engine pistons are not normally expected to be made of plastics or even composites, but before now the latter have been applied to an Over Head ...
Unamka, Ugochukwu Gregory +1 more
core
Advanced Engineering Materials, EarlyView.Aluminum and nitride coatings are used in industry because they are hard, resist wear, and protect against oxidation. Adding boron can improve friction behavior and other properties. This study tests coatings on surfaces with different finishes. Results show smoother surfaces perform better, while rough ones wear faster, although coatings can reduce ...
Adrián Claver +9 more
wiley +1 more source
Fatigue under Service Load (V)
Journal of the Society of Materials Science, Japan, 1968 T. Tanaka, T. Shibata
openaire +5 more sources
Advanced Engineering Materials, EarlyView.This study shows that superalloys used in aircraft engine disks become much more prone to deformation at high temperatures if they have been strained during manufacturing. This effect increases with the level of prior strain but eventually reaches a limit.
Fabio Machado Alves da Fonseca +9 more
wiley +1 more source
Dynamic simulation of semi-active suspension systems for durability analysis [PDF]
, 2007 The benefits of vehicles with semi-active suspension systems have been widely accepted, mainly for improvement in ride and handling, over the passive system.
Ramli, Rahizar
core
Advanced Engineering Materials, EarlyView.Composite Ti–6Al–4V–epoxy lattice structures are additively manufactured and epoxy infiltrated for cyclic loading. At low lattice volume fractions, hybridization produces synergistic gains in stiffness and energy dissipation. At higher volume fractions, synergy diminishes, although composites still exceed metallic lattices in specific energy ...
Joey Tallon +3 more
wiley +1 more source
Modelling fatigue spectra of aircraft structure under gust loads [PDF]
, 2012 Cette thèse est consacrée à l'analyse de fatigue et de tolérance aux dommages des structures d'avions soumis aux rafales de vent. L'analyse de fatigue et de tolérance aux dommages est un enjeu essentiel dans la conception des structures d'avions.
Reytier, Thomas
core
Advanced Engineering Materials, EarlyView.This review highlights advances in lightweight, lead‐free polymer nanocomposites for diagnostic X‐ray shielding. By linking filler chemistry, dispersion, architecture, and photon interaction mechanisms, it establishes structure–performance relationships guiding material design.
Aklilu G. Messele +2 more
wiley +1 more source
A Dislocation Perspective on Strength and Toughness in Ceramics
Advanced Engineering Materials, EarlyView.Dislocations in ceramics enjoy a long but yet under‐appreciated history. The three research waves for dislocations in ceramics highlight the topic evolution over the last 90 years. This review focuses on the impact of dislocation on strength and toughness in ceramics.
Xufei Fang
wiley +1 more source
Comparison of Triply Periodic Minimal Surface Energy Absorbers Under Uniaxial Compressive Loading
Advanced Engineering Materials, EarlyView.This study investigates LCD 3D printed Triply Periodic Minimal Surface (TPMS) structures as mechanical energy absorbers. By comparing various base designs and layered combinations under uniaxial compression, it identifies that a Diamond‐Gyroid sandwich structure offers superior performance.
Sergej Grednev +2 more
wiley +1 more source