Results 121 to 130 of about 2,329 (305)
Composite Heat Sink Material for Superconducting Tape in Fault Current Limiter Applications. [PDF]
Materials (Basel), 2020 Pekarčíková M +10 more
europepmc +1 more source
Compare A 700 V, 150 Ampere Resistive And Inductive Superconductig Fault Current Limiters
, 2018 This thesis describes how we can tackle the problem of fault currents in power systems. Two of the possible solutions are the inductive and resistive superconducting fault current limiters.
Yahaya, Abuabakar Sadiq
core
OVERCURRENT RELAY COORDINATION IN DISTRIBUTED GENERATION WITH FAULT CURRENT LIMITER
, 2017 The distribution network has many advantages when it is connected to distributed generation (DG). Some problems in coordination of protection devices will occur in the presence of DG, due to change in short circuit level at different points.
Amit A. Chatte (5115593), Amit A. Chatte
core +1 more source
FEBS Open Bio, EarlyView.RoboMic is an automated confocal microscopy pipeline for high‐throughput functional imaging in living cells. Demonstrated with fluorescence recovery after photobleaching (FRAP), it integrates AI‐driven nuclear segmentation, ROI selection, bleaching, and analysis.
Selçuk Yavuz +6 more
wiley +1 more source
Fault-current limiter using a superconducting coil [PDF]
, 1982 A novel circuit, consisting of solid-state diodes and a biased superconducting coil, for limiting the fault currents in three-phase ac systems is presented.
Paice, D. A., Boenig, H. J.
core
FEBS Open Bio, EarlyView.Unique biological samples, such as site‐specific mutant proteins, are available only in limited quantities. Here, we present a polarization‐resolved transient infrared spectroscopy setup with referencing to improve signal‐to‐noise tailored towards tracing small signals. We provide an overview of characterizing the excitation conditions for polarization‐
Clark Zahn, Karsten Heyne
wiley +1 more source
On Fault Current Limiting and Specification of Superconducting Fault Current Limiters
IEEJ Transactions on Power and Energy, 1994 Seiji Sekine, Tanzo Nitta
openaire +2 more sources
REDUCING FAULT CURRENT BY USING NON SUPERCONDUCTING FAULT CURRENT LIMITER
, 2020 +919494888858,+91934653046 In the above fig the fault occurs and the voltage becomes zero and the current is so high (upto400Amps). There is a equipment like Circuit Breakers, Transformers, Relays are most costly equipment are placed increasing day by ...
Ameer Shaik +3 more
core
BEHAVIOUR OF SUPERCONDUCTING FAULT CURRENT LIMITER UNDER FAULT CONDITION
, 2021 Now a days due to increase in electricity demand for the purpose of industrialization, agriculture, domesticand educational etc there exists more chances of fault occurance.
KARUNA L. BARI, S. M. SHEMBEKAR
core
FEBS Open Bio, EarlyView.This protocol paper outlines methods to establish the success of a time‐resolved serial crystallographic experiment, by means of statistical analysis of timepoint data in reciprocal space and models in real space. We show how to amplify the signal from excited states to visualise structural changes in successful experiments.
Jake Hill +4 more
wiley +1 more source