Results 101 to 110 of about 397 (158)

Electronic fault current limiter based on resonant circuit controlled by power semiconductor devices [PDF]

open access: yes, 2006
This dissertation presents a study of a resonant fault current limiter (FCL) controlled by power semiconductor devices. Initially the operation of two ideal resonant circuit topologies as fault current limiter are discussed.
Lanes, Matusalém Martins
core  

A Novel Overcurrent Suppression Strategy during Reclosing Process of MMC-HVDC

open access: yesApplied Sciences, 2019
A modular multilevel converter based high-voltage DC (MMC-HVDC) system has been the most promising topology for HVDC. A reclosing scheme is usually configured because temporary faults often occur on transmission lines especially when overhead lines are ...
Bin Jiang, Yanfeng Gong
doaj   +1 more source

Enhancing stability of Photovoltaic-Energy storage-Direct current-Flexibility power system with a novel integrated Superconducting Magnetic Energy Storage-Fault Current Limiter (SMES-FCL)

open access: yesJournal of Physics: Conference Series
Abstract In order to enhance the stability and reliability of the Photovoltaic-Energy storage-Direct-Flexible (PEDF) system, a novel line-compensation superconducting magnetic energy storage-fault current limiter (SMES-FCL) was designed to address voltage fluctuations and fault current limiting issues.
Baohua Liu   +4 more
openaire   +1 more source

An effect of fault current limiter to distributed generator shaft torque increase under voltage sag [PDF]

open access: yes, 2007
Voltage sags originated at the transmission level can have a very adverse effect on distributed generators running at distribution levels. A fault current limiter (FCL) can be an effective means to limit the voltage sag impact.
Tanabe, Takayuki   +7 more
core   +1 more source

Optimum Coordination Approach for Directional Overcurrent Relays in Interconnected Power Systems Considering Uncertainty in Photovoltaic Generation

open access: yesIEEE Access
Optimizing the sensitivity and speed of the overcurrent protection system in the presence of distributed generation units while also ensuring the cost-effective design of the fault current limiter (FCL) represents great challenges for engineers.
Mahmoud A. Elsadd   +4 more
doaj   +1 more source

Development of Bulk Bi2+xSr3-yCa yCu 2O8+delta Superconductors by Partial-Melting Route for Fault Current Limiters Application

open access: yesMaterials Research, 2002
The production of bulk Bi2+xSr3-yCa yCu 2O8+delta (Bi-2212) superconductors for fault current limiter application was developed via a partial-melting route.
Bojan A. Marinkovic   +6 more
doaj   +1 more source

Design of a multifunction novel flexible fault current limiter for AC distribution network. [PDF]

open access: yesPLoS One, 2021
Liu Y   +7 more
europepmc   +1 more source

Fault Current Limiter and Mechanical DC CB-Based Protection Against Valve-Side SPG Faults in HB-MMC Bipolar System

open access: yesIEEE Access
Valve-side single-phase-to-ground (SPG) faults are atypical yet critical for the operation of half-bridge (HB) Modular Multilevel converter (MMC) bipolar or asymmetrical monopolar systems.
Muhammad Usman   +2 more
doaj   +1 more source

Critical Current Determination in High-Quality YBCO Rings for Application in a Fault Current Limiter [PDF]

open access: yes, 2001
v, 28 p.The first section of this work is an introduction to basic properties of superconductors and the theory of operation of a superconducting fault current limiter (FCL).
Weber, Jonathan M.
core  

Transient simulation and analysis for saturated core high temperature superconducting fault current limiter [PDF]

open access: yes, 2007
In this paper, the transient performance of a magnetic core fault current limiter (FCL) saturated by high temperature superconducting (HTS) dc bias winding is investigated by using both 3-D field-circuit coupled simulation and magnetic circuit analysis ...
Zhao, C   +6 more
core   +1 more source

Home - About - Disclaimer - Privacy