Results 91 to 100 of about 6,133,186 (147)

Analysis and mitigation of PQ disturbances in grid connected system using fuzzy logic based IUPQC. [PDF]

Sci Rep, 2023
Ravi T, Kumar KS, Dhanamjayulu C, Khan B, Rajalakshmi K.   +4 more
europepmc   +1 more source

Design and application of superconducting fault current limiter in a multiterminal HVDC system [PDF]

, 2017
Voltage source converter based HVdc (VSC-HVdc) systems are prone to high short-circuit current during transmission line faults. The situation for multiterminal HVdc (MTDC) systems is worse.
Yuan, Weijia, Liang, Fei, Le Blond, Simon, Yang, Qingqing, Zhang, Min, Li, Jianwei   +5 more
core   +1 more source

Essential Material Knowledge and Recent Model Developments for REBCO-Coated Conductors in Electric Power Systems. [PDF]

Materials (Basel), 2021
Trillaud F, Dos Santos G, Gonçalves Sotelo G.   +2 more
europepmc   +1 more source

Fault current limiting dynamic voltage restorer for power quality improvement in distribution system (case study: air force feeder)

Journal of Electrical Systems and Information Technology
Air force distribution feeder, or R1-G4, in Bahir Dar substation is affected by total harmonic distortion from nonlinear loads, voltage sag from short-circuit faults that occurred on the system, and voltage swell.
Yechale Amogne, Efrata Admas, Wondifraw Asmare Alemu   +2 more
doaj   +1 more source

Optimal Multiple FCLs Allocation Considering DG Penetration in Meshed Network With Multi-Level Voltages

Iranian Journal of Electrical and Electronic Engineering, 2020
Increasing the short circuit current due to the penetration of distributed generations (DGs) in various voltage levels and meshed topology is a basic problem in power systems.
M. Hosseinpour, J. Sadeh
doaj  

A Remaining Useful Life Prognosis of Turbofan Engine Using Temporal and Spatial Feature Fusion. [PDF]

Sensors (Basel), 2021
Peng C, Chen Y, Chen Q, Tang Z, Li L, Gui W.   +5 more
europepmc   +1 more source

Design of a 10kV,500A Inductive Superconducting Fault Current Limiter

, 2017
The design aspect of a 10kV,500A inductive superconducting fault current limiter was analyzed. The effect of the superconductor in the fault current limiter was defined. When placed in the system, in the absence of fault current,the superconducting fault
Akejelu, Daniel Limi
core  

Coordinated Source-Grid fault current limiting strategy in HVDC grids based on fault severity and quantitative limitation demand

International Journal of Electrical Power & Energy Systems
Reliable fault current limitation is critical in high-voltage direct current (HVDC) grids due to the fast dynamics and low fault tolerance of power electronic equipment, as well as the high cost of DC circuit breakers (DCCBs). To address these challenges,
Yuhong Wang, Chunsheng Guo, Ting Du, Jianquan Liao, Nengqiao Wei, Dachuan Yu   +5 more
doaj   +1 more source

The impact of fault current limiter in power system performance [PDF]

, 2009
Continues growth of electrical energy demand is resulting in a corresponding increase in the short circuit in power system. Several solutions have been implemented, including the use of Fault Current Limiter (FCL), in order to reduce circuit breakers ...
Mohd. Ariff, Mohd. Aifaa, Mohd Ariff, Mohd Aifaa   +1 more
core   +2 more sources

Using non-superconducting fault current limiter as inrush current limiter

, 2011
In this paper, inrush current limitation of transformer using a bridge type fault current limiter (FCL) as inrush current limiter is proposed.
Seyedbehzad Naderi (14745067), Jafari, M (15697139), Hagh, MT (15644669)   +2 more
core   +1 more source