Results 11 to 20 of about 6,126 (298)
A Review of Current-Limiting Control of Grid-Forming Inverters Under Symmetrical Disturbances
IEEE Open Journal of Power Electronics, 2022 Grid-forming (GFM) inverters are recognized as a viable solution to increase the penetration of renewable energy in bulk power systems. However, they are physically different from synchronous generators in terms of overcurrent capability.
Bo Fan +4 more
doaj +1 more source
IET Generation, Transmission & Distribution, 2022 The invention of doubly‐fed induction generator (DFIG) brings the wind energy one step ahead as renewable power generation. But the performance of the grid‐connected DFIGs are greatly affected by grid disturbances as their stator windings are interfaced ...
Md. Arafat Hossain +5 more
doaj +1 more source
High Voltage, 2019 With the continuous expansion of power grid capacity, the problem of short-circuit current exceeding the standard is becoming increasingly serious. Fault current limiter is a promising solution and is gradually becoming a research hotspot. In this study,
Jiaxin Yuan +5 more
doaj +1 more source
Development and test of resistive superconducting fault current limiter; acting time and its recovery conditions [PDF]
, 2014 Resistive-type of superconducting fault current limiters (RSFCL) have been developed for medium voltage class aiming to operate at 1 MVA power capacity and short time recovery (< 2 s).
Baldan, Carlos A +4 more
core +2 more sources
IET Generation, Transmission & Distribution, 2023 This paper proposes a new adaptive nonlinear extended state observer‐based model predictive controller (ANLESO‐MPC) for residual current compensation (RCC) inverters to compensate fault characteristics in resonant grounded power systems (RGPSs).
Warnakulasuriya Sonal Prashenajith Fernando +1 more
doaj +1 more source
Analysis of energy dissipation in resistive superconducting fault-current limiters for optimal power system performance [PDF]
, 2011 Fault levels in electrical distribution systems are rising due to the increasing presence of distributed generation, and this rising trend is expected to continue in the future.
Blair, Steven Macpherson +4 more
core +1 more source
TESTS OF HTS 2G SUPERCONDUCTING TAPES USING THE LABVIEW ENVIRONMENT [PDF]
Applied Computer Science, 2018 HTS 2G superconducting tapes without stabilizer are used for the construction of superconducting fault current limiters. The characteristics R =f(T) of the superconducting tape is essential for design of superconducting current limiters and analysis of ...
Rafał KWOKA +2 more
doaj +1 more source
Modeling the Non Linear Behavior of a Magnetic Fault Current Limiter
Advanced Electromagnetics, 2015 Fault Current Limiters are used in a wide array of applications from small circuit protection at low power levels to large scale high power applications which require superconductors and complex control circuitry.
P. R. Wilson
doaj +1 more source
Superconducting fault current limiter application in a power-dense marine electrical system [PDF]
, 2011 Power-dense, low-voltage marine electrical systems have the potential for extremely high fault currents. Superconducting fault current limiters (SFCLs) have been of interest for many years and offer an effective method for reducing fault currents.
Blair, Steven Macpherson +5 more
core +1 more source
Application of multiple resistive superconducting fault-current limiters for fast fault detection in highly interconnected distribution systems [PDF]
, 2013 Superconducting fault-current limiters (SFCLs) offer several benefits for electrical distribution systems, especially with increasing distributed generation and the requirements for better network reliability and efficiency.
Blair, Steven Macpherson +3 more
core +1 more source