Results 131 to 140 of about 447,699 (304)
In modular multilevel converters-based DC power grid, short faults develop rapidly and have complex characteristics. The power electronic converter has a limited ability to withstand overcurrent. So, protection needs to quickly identify the fault area in
Yao Sun +3 more
doaj +1 more source
Lessons learned in creating spacecraft computer systems: Implications for using Ada (R) for the space station [PDF]
Twenty-five years of spacecraft onboard computer development have resulted in a better understanding of the requirements for effective, efficient, and fault tolerant flight computer systems.
Tomayko, James E.
core +1 more source
Objective The objective of this article is to identify perceptions of SLE patients regarding artificial intelligence (AI)‐based online symptom assessment tools, and the potential of these tools to address diagnostic barriers. Methods Adults from our SLE research cohort were invited to participate in 60‐90 minute virtual focus groups concerning their ...
Olivia A. Stein +7 more
wiley +1 more source
Thermoreflectance Detection of Point Defects Resulting from Focused Ion Beam Milling
Focused ion beam (FIB) milling is a common tool for nanoscale material processing, however irradiation damage, redeposition, and contamination can occur. We use several characterization tools to show FIB‐induced effects beyond 1 mm from the milled area.
Thomas W. Pfeifer +3 more
wiley +1 more source
A novel directional pilot protection method for EHV transmission lines based on S-transform and SVM
To address the issues of insufficient reliability and low sensitivity of traveling-wave (TW)-based protection caused by fault condition attributes, i.e., fault resistance and fault angle, this paper proposes a novel directional pilot protection method ...
Zhenwei Guo +3 more
doaj +1 more source
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Analysis of Processing Method of Protection Re-closure Failures in 220 kV Power Line
The paper analyzed cause of re-closure failures of power supply line, and introduced a kind of location method which uses fault information and protection information to synthetically judge line fault.
LIU Feng
doaj
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Influence of an Argon/Silane Atmosphere on the Temperature of a Thermal Plasma
The influence of a silane‐doped argon atmosphere on the chemical composition and temperature of a thermal nontransferring argon plasma is investigated using optical emission spectroscopy. As a result of the high amount of free electrons resulting from the stepwise ionization and dissociation of the silane molecule, even a silane addition of 0.01 vol ...
Lena Kreie +4 more
wiley +1 more source
Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres
This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann +3 more
wiley +1 more source

