Results 121 to 130 of about 453,200 (223)
The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert +6 more
wiley +1 more source
The wettability of aluminum droplets (Al) on different copper substrates (Cu), where liquid Al spreads on solid Cu surfaces to form a liquid–solid interface, is studied numerically and experimentally. The experimental and numerical results show good agreement in the fast‐spreading regime.
Shan Lyu +8 more
wiley +1 more source
Aspectos de la humanidad de Jesús a partir de Mc 6,1-6
Este artículo profundiza en la humanidad de Jesús a partir de Mc 6,1-6, en diálogo con la confesión cristológica del Concilio de Nicea. A través de un análisis exegético e histórico, se muestra cómo Marcos presenta a Jesús como verdadero hombre inserto ...
Iranzu Galdeano
doaj
<i>In situ</i> synthesis of MXene@Iron oxide nanoparticle composites <i>via</i> pulsed laser ablation in liquid applied for electrochemical H<sub>2</sub>O<sub>2</sub> reduction. [PDF]
Lorencová L +10 more
europepmc +1 more source
EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk +7 more
wiley +1 more source
The subject of this work is the development of a corrosion‐protective coating on steel sheets for form hardening. Rapid heating in an extreme high vacuum (XHV)‐adequate atmosphere is a useful method to prevent oxidation during alloying of 22MnB5 and aluminum to obtain a metallurgical bonding.
Lorenz Albracht +5 more
wiley +1 more source
Next-generation photo-Fenton treatment using MIL-100(Fe) synthesized through a green route for sustainable remediation of pharmaceutical wastewater. [PDF]
Abou-Elyazed AS +4 more
europepmc +1 more source
Surface Tension Measurement of Ti‐6Al‐4V by Falling Droplet Method in Oxygen‐Free Atmosphere
In this article, the temperature‐dependent surface tension of free falling, oscillating Ti‐6Al‐4V droplets is investigated in both argon and monosilane doped, oxygen‐free atmosphere. Droplet temperature and oscillation are captured with one single high‐speed camera, and the surface tension is calculated with Rayleigh's formula.
Johannes May +9 more
wiley +1 more source
Modulation of the Spin State of Atomic Fe-N<sub>4</sub> Sites with Interlayer-Adjacent Ir-N<sub>4</sub> for Superior ORR Activity. [PDF]
Tan Y +7 more
europepmc +1 more source
Cermets (60 vol.% AISI 316L stainless steel, 40 vol.% recycled MgO), intended for use in aluminum electrolysis, were pre‐oxidized in three furnaces with different heating technologies and subjected to a cryolite corrosion test. The different atmospheres influenced the formation of oxide layers, which in turn affected corrosion resistance and ...
Patricia Kaiser +4 more
wiley +1 more source

