Results 101 to 110 of about 64,489 (314)
An evaluation of weld metal nitrogen retention and properties in 316NL austenitic stainless steel
, 2011 A series of tests were conducted using varying levels of nitrogen and helium in a conventional argon shielding gas when welding 316LN austenitic stainless steel. The outcome was that a 15 per cent nitrogen addition to the argon shielding gas had the most
Baker, Thomas +2 more
core +1 more source
Emerging Materials and Future Strategies for Solid Oxide Electrochemical Cells
Advanced Energy Materials, EarlyView.Solid oxide electrochemical cells operate under strongly coupled electrochemical and thermodynamic conditions, where performance is constrained by interactions among crystal structure, defect chemistry, and interfacial evolution. This review, based on a structure‐defect‐property‐durability framework, reveals the roles of lattice symmetry and defect ...
Qiuchun Lu +4 more
wiley +1 more source
Effect of MoO3 Doping on the Microstructure and Magnetic Properties of Mn0.816Zn0.091Fe2.093MoxO4
CeramicsThe traditional solid-state method was employed in this study to prepare Mn-Zn ferrite. By adjusting the sintering temperature and the MoO3 doping ratio, the evolution of its structural and magnetic properties was systematically investigated. Fe2O3, MnO,
Shuxin Liu +5 more
doaj +1 more source
Data‐Guided Photocatalysis: Supervised Machine Learning in Water Splitting and CO2 Conversion
Advanced Intelligent Discovery, EarlyView.This review highlights recent advances in supervised machine learning (ML) for photocatalysis, emphasizing methods to optimize photocatalyst properties and design materials for solar‐driven water splitting and CO2 reduction. Key applications, challenges, and future directions are discussed, offering a practical framework for integrating ML into the ...
Paul Rossener Regonia +1 more
wiley +1 more source
Фізика і хімія твердого тілаCoFe2O4 nanoparticles were synthesized from different parts of the Physalis. Characterization techniques including XRD and FTIR confirmed the spinel structure.
Mariia Liaskovska +2 more
doaj +1 more source
Metallurgy of armour exhibited at the Palace Armoury, Valletta, Malta [PDF]
, 2004 The metallurgy of ten armour pieces from the Palace Armoury Collection in Malta was examined. Results showed that out of ten artefacts examined, six were produced in low carbon steel, one from a high carbon steel and three were made from wrought iron ...
Hallam, David +5 more
core
Fatigue crack-growth rate in ferrite martensite dual-phase steel
, 1991 An empirical study is made on the fatigue crack growth rate in ferrite-martensite dual-phase (FMDP) steel. Particular attention is given to the effect of ferrite content in the range of 24.2% to 41.5% where good fatigue resistance was found at 33.8 ...
Ye ZJ +2 more
core +1 more source
Sol-Gel Auto-Combustion Synthesis of Spinel Type Ferrite Nanomaterials
The recent developments and trends of sol-gel auto-combustion method for spinel ferrite nanomaterial synthesis are briefly discussed and critically analysed.
Šutka, Andris, Mežinskis, Gundars
core
Advanced Physics Research, EarlyView.Sintering ZnAl0.1Sn0.1Fe1.8O4 nanoparticles at 1200°C optimizes structural lattice dynamics, significantly enhancing both macroscopic elastic stiffness and high‐frequency dielectric response through synergistic Al3+ stabilization and Sn4+‐driven charge transport. ABSTRACT In this work, ZnAl0.1Sn0.1Fe1.8O4 (ZASFO) ferrites were synthesized via a sol–gel
Matin Patel +4 more
wiley +1 more source
Magnetic and Electric Properties of Magneto polymer Composites
Advances in Electrical and Electronic Engineering, 2004 Permeability spectra of MnZn ferrite composite materials, prepared by mixing ferrite particles with PVC, have been studied. As the ferrite filler content decreases in composite, the quasistatic permeability of the rotation component decreases and ...
Jozef Slama +4 more
doaj