Results 141 to 150 of about 132,168 (250)

Influence of Ultrasonic‐Assisted Milling on Surface Integrity and Fatigue Strength of a Low Alloy Steel

Fatigue &Fracture of Engineering Materials &Structures, EarlyView.
ABSTRACT The milling process significantly influences the surface integrity of metallic components through machining induced near‐surface residual stresses. Modern hybrid machining processes, such as ultrasonic‐assisted milling (USAM), offer the potential to induce beneficial near‐surface compressive residual stresses compared to the near‐surface ...
Lorenz Engelking, Mauro Madia, Dirk Schröpfer, Julius Kruse, Romeo Saliwan Neumann, Thomas Kannengießer   +5 more
wiley   +1 more source

Application of Zinc Ferrite Nanoparticles for the Magnetic Removal of Algae That Bind Cadmium. [PDF]

Nanomaterials (Basel)
Koska P, Fóris T, Gráczer K, Állné Ilosvai ÁM, Kristály F, Daróczi L, Vanyorek L, Viskolcz B.   +7 more
europepmc   +1 more source

Medium‐Cycle Fatigue Behavior of Three Metallic Materials and a Welded Steel Following Gaseous Hydrogen Soaking

Fatigue &Fracture of Engineering Materials &Structures, EarlyView.
ABSTRACT This study investigates the impact of hydrogen soaking on the medium‐cycle fatigue behavior of various metallic materials commonly used in gas transmission pipelines. The tested materials include ex‐service gray cast iron, ex‐service X52 carbon steel, brass, and welded X52 carbon steel.
E. Kufoin, A. Bannister, M. Brown, D. Engelberg, N. Kahlon, F. Scenini, Y. Zhou, L. Susmel   +7 more
wiley   +1 more source

Zirconia Ceramics Doped with Ferrite for Solar Thermal Systems. [PDF]

Nanomaterials (Basel)
Rada V, Ungureşan ML, Rednic V, Rada S, Lungu F, Culea E.   +5 more
europepmc   +1 more source

AC measurements and magnetic properties of magnesium ferrite and its composites with reduced graphene oxide (rGO) and polypyrrole (PPy). [PDF]

Sci Rep
Ibrahim B, El Shater RE, Saafan SA, Omar MK.   +3 more
europepmc   +1 more source

Ferrite capsulation by the ferrite plating.

Journal of the Surface Finishing Society of Japan, 1989
Takao SAITO, Masao OOISHI
openaire   +2 more sources

A Low‐Cost and Compact High‐Frequency Gallium Nitride Gradient Power Amplifier for Low‐Field MRI

Magnetic Resonance in Medicine, Volume 95, Issue 5, Page 2992-2999, May 2026.
ABSTRACT Purpose To reduce the upfront cost of small, low‐field MRI systems, while expanding the capabilities of their gradient systems. Methods A gradient power amplifier was designed to leverage the lowering cost of Gallium Nitride (GaN) power transistors and high speed logic, to achieve high efficiency and responsiveness for driving gradient coils ...
N. Reid Bolding, Jacob Hannan, Christopher Vaughn, Aria Patel, Snow Lin, Jessie E. P. Sun, William Grissom, Mark A. Griswold   +7 more
wiley   +1 more source

Stimuli-responsive chitosan-coated ferrite nanocarriers for targeted capsaicin delivery and core-dependent HepG2-selective bioactivity. [PDF]

Sci Rep
Bakr E, Elshami FI, Okba EA, Mansour H, Shaban SY.   +4 more
europepmc   +1 more source

Effect of PWHT and Electrical Parameters on Austenitic Phase, Sigma Phase and Corrosion in Duplex Steels S32205

Engineering Reports, Volume 8, Issue 4, April 2026.
Welding power and post‐weld heat treatment (PWHT) at 850°C influence phase transformations in S32205 duplex stainless steel, promoting sigma phase formation and reducing corrosion resistance. PWHT at 850°C also replicates HAZ‐like microstructures in base metal, enabling improved characterization of weld joint properties.
Sandra Chacón‐Fernández, José L. Meseguer‐Valdenebro, Andrea Peña Martín   +2 more
wiley   +1 more source

Synthesis, characterization of Mg doped CuFe₂O₄ nanoparticles for potential anticancer applications. [PDF]

Sci Rep
Ali M, Zein N, Abdo MA, Adel G, Sitohy B.   +4 more
europepmc   +1 more source