Results 81 to 90 of about 155,263 (312)

Dielectric Barrier Discharge Plasma Deoxidation of Natively Oxide Layer of Copper Powders in a Fluidized Bed

Advanced Engineering Materials, EarlyView.
This paper presents a novel approach to reducing oxide layers on metal powders using low‐temperature hydrogen dielectric barrier discharge plasmas at atmospheric pressure. Unlike conventional hydrogen‐plasma reductions, the powders do not contact the plasma directly.
Shukang Zhang, Annett Wollmann, Thomas Gimpel, Alfred P. Weber   +3 more
wiley   +1 more source

Effect of CNT embedding angle on tensile behavior and dislocation mechanisms in magnesium matrix composites: a molecular dynamics study

Results in Physics
This study explores the influence of CNT embedding angles on the tensile behavior and dislocation evolution of CNT/Mg composites using molecular dynamics simulations.
Chentong Zhao, Jiming Zhou, Yunfeng Bai, Kang Yun, Lehua Qi   +4 more
doaj   +1 more source

Pengaruh penambahan silane terhadap kekuatan fleksural reinforced composite yang diperkuat dengan glass fiber non-dental

The effect of silane addition on the flexural strength of non-dental glass fiber reinforced composite

Jurnal Kedokteran Gigi Universitas Padjadjaran, 2019
Pendahuluan: Fiber reinforced composite terdiri dari gabungan resin komposit dan fiber. Kandungan tersebut dapat meningkatkan kekuatan fleksural. Kekuatan fleksural sangat diperlukan pada material kedokteran gigi supaya tahan terhadap tekanan oklusal ...
Farahdina Maulida, Widya Puspita Sari, Darmawangsa Darmawangsa   +2 more
doaj   +1 more source

Some fundamental fracture mechanisms applicable to advanced filament reinforced composites [PDF]

Stress analysis and fracture mechanisms of advanced fiber reinforced ...
Berry, J. M., Gatti, A., Mullin, J. V.
core   +1 more source

Ceramic fiber reinforced glass-ceramic matrix composite [PDF]

, 1993
A slurry of BSAS glass powders is cast into tapes which are cut to predetermined sizes. Mats of continuous chemical vapor deposition (CVD)-SiC fibers are alternately stacked with these matrix tapes. This tape-mat stack is warm-pressed to produce a 'green'
Bansal, Narottam P.
core   +1 more source

Multifunctional Crushing and Piezoresistive Self‐Sensing in Conductive Epoxy/CNT‐Coated Polyetherimide TPMS Lattices

Advanced Engineering Materials, EarlyView.
This study reports lightweight polyetherimide triply periodic minimal surfaces lattices coated with carbon nanotube‐reinforced epoxy that combine mechanical robustness with self‐sensing. The conformal coating enhances stiffness, strength and energy absorption while enabling reliable strain monitoring.
A. Triay, J. Schneider, P. Harrison, S. Kumar   +3 more
wiley   +1 more source

Fracture mechanism of BJ-CVI SiC lattices with four distinct structures based on finite element simulation and digital image correlation

Materials & Design
SiC ceramic lattice structures (CLSs) have become increasingly popular in engineering applications due to their remarkable specific strength and thermal properties.
Saisai Zhu, Guoqing Liu, Pei Wang, Jian Zhang, Lijun Yang, Mingwei Wu, Nan Kang, Mohamed El Mansori, Konda Gokuldoss Prashanth, Yulei Zhang   +9 more
doaj   +1 more source

Influence of fiber aspect ratio on the stress- rupture life of discontinuous fiber composites [PDF]

Critical aspect ratio and stress rupture of discontinuous fiber reinforced ...
Jech, R. W.
core   +1 more source

Fiber Reinforced Composites - A Review

Journal of Material Science & Engineering, 2017
Fiber-reinforced composites are essentially axial particulates embedded in fitting matrices. The primary objective of fiber-reinforced composites it to obtain materials with high strength in conjunction with higher elastic modulus. The strength elevation is however affected with applied load transiting from matrix to fibers, interfacial bonding between
Prashanth S, Subbaya KM, Nithin K, Sachhidananda S   +3 more
openaire   +1 more source

Surface Tension Measurement of Ti‐6Al‐4V by Falling Droplet Method in Oxygen‐Free Atmosphere

Advanced Engineering Materials, EarlyView.
In this article, the temperature‐dependent surface tension of free falling, oscillating Ti‐6Al‐4V droplets is investigated in both argon and monosilane doped, oxygen‐free atmosphere. Droplet temperature and oscillation are captured with one single high‐speed camera, and the surface tension is calculated with Rayleigh's formula.
Johannes May, Finn‐Lennard Janthur, Lena Kreie, Michael Müller, Sarah Seffer, Nick Schwarz, Jörg Hermsdorf, Thomas Hassel, Stefan Kaierle, Ludger Overmeyer   +9 more
wiley   +1 more source