Results 201 to 210 of about 2,499,492 (372)

A Partial Discharge Detection Approach in Distribution Cabinets Using a Mach-Zehnder Interferometer. [PDF]

Sensors (Basel)
Wang J, Zhang Y, Gu X.
europepmc   +1 more source

Direct Consolidation of Copper–Graphene Composite by Rotary Swaging

Advanced Engineering Materials, EarlyView.
The applicability of the rotary swaging method for preparation of electroconductive copper–graphene composite by direct consolidation of powders is proven. The consolidated material features advantageous microstructure featuring fine grains and twins, with homogeneous distribution of graphene, primarily along the twin boundaries, which contribute to ...
Radim Kocich, Lenka Kunčická, Pavel Czernek   +2 more
wiley   +1 more source

INTRODUCTION OF CHELATE BOND TO FIBER

, 1957
Nobumasa Hōjō
openalex   +2 more sources

Design and Evaluation of 3D‐Printed Polylactic Acid Composites Reinforced with Biodegradable Bamboo Powder and Jute Powder

Advanced Engineering Materials, EarlyView.
The study investigates 3D‐printed polylactic acid (PLA) composites with biodegradable bamboo and jute powder fillers. Mechanical, thermal, structural properties, and rheological behavior are discussed to evaluate composite performance. Morphological characterization indicates uniform dispersion and adhesion of the fillers in the PLA matrix with the ...
Vimukthi Dananjaya, Yongqi Wang, Yashi Zheng, Prasad Potluri, Chamil Abeykoon   +4 more
wiley   +1 more source

An Experimental Study on the Development of Elastic Fibers

, 1954
Yukihiko Higuti
openalex   +2 more sources

Fractographic Analysis and Fatigue Behavior of Additively Manufactured Ni‐Superalloy Components with Post Processing Heat Treatment and Hot Isostatic Pressing

Advanced Engineering Materials, EarlyView.
A study of mechanical properties and fractography of PBF‐LB/M‐built Inconel 718, performing heat treatments and hot‐isostatic pressing, is presented. Ultimate tensile strength and fatigue behavior are evaluated, examining differences in maximum load behavior, elongation, and regimes of fatigue.
David Sommer, Ben Truetsch, Cemal Esen, Ralf Hellmann   +3 more
wiley   +1 more source

One-dimensional compression behavior of calcareous sand cemented with EICP and coir fiber. [PDF]

Sci Rep
Jiang X, Wang H, Yang H, Yin J, Shen B.
europepmc   +1 more source

STUDIES ON THE ACRYLIC FIBER

, 1958
Isao Okamura
openalex   +2 more sources

Enhanced Mechanical Properties of Injectable Chitosan–Guar Gum Hydrogel Reinforced with Bacterial Cellulose Nanofibers for Tissue Engineering Applications

Advanced Engineering Materials, EarlyView.
This study presents the development and characterization of injectable nanocomposite hydrogels based on N‐succinyl chitosan, oxidized guar gum, and bacterial cellulose nanofibers. Emphasizing enhanced mechanical properties and biocompatibility, the hydrogels exhibit fast gelation, improved structural integrity, and reduced swelling. Their potential for
Raimundo Nonato Fernandes Moreira Filho, Pascale Chevallier, Silvia Rodriguez Fernandez, Maud Viallon, Matheus Xavier de Oliveira, Ana Lorena de Brito Soares, Diego Mantovani, Judith Pessoa de Andrade Feitosa, Rodrigo Silveira Vieira   +8 more
wiley   +1 more source

Dyeing of Synthetic Fibers

, 1956
Haruo Yoshitake
openalex   +2 more sources