Results 111 to 120 of about 84,862 (288)

Analyzing the impact of recycled aggregate and waste glass powder on the fresh and mechanical properties of concrete

open access: yesEnvironment Conservation Journal
This study examines the effects of recycled aggregate and waste glass powder on concrete's fresh and mechanical characteristics. This investigation used recycled aggregate and waste glass powder content of 0%, 10%, 20%, 30%, 40%, and 50% to partially ...
Umesh Jhakal, Sunil Thakur, Sumesh Jain
doaj   +1 more source

Sustainable Materials Design With Multi‐Modal Artificial Intelligence

open access: yesAdvanced Science, EarlyView.
Critical mineral scarcity, high embodied carbon, and persistent pollution from materials processing intensify the need for sustainable materials design. This review frames the problem as multi‐objective optimization under heterogeneous, high‐dimensional evidence and highlights multi‐modal AI as an enabling pathway.
Tianyi Xu   +8 more
wiley   +1 more source

Influence of Saturation Degree of Recycled Coarse Aggregate on the Mechanical Properties of Fully Recycled Aggregate Concrete and Mechanism Analysis

open access: yesBuildings
The application of fully recycled aggregate concrete (FRAC) promotes sustainable construction, but its mechanical properties are often unstable due to the high absorption and variability of recycled aggregates.
Xianliang Tan   +7 more
doaj   +1 more source

Data‐Driven Modeling of Composition–Processing–Microstructure Relations for Recycled Aluminum Cast Alloys

open access: yesAdvanced Science, EarlyView.
Interpretable machine learning reveals how composition and processing govern the formation and microstructural burden of Fe‐rich intermetallic compounds in recycled Al–Si–Fe–Mn alloys. By separating morphology selection from morphology‐conditioned burden partitioning, this framework shows that identical Fe contents can yield different intermetallic ...
Jaemin Wang   +2 more
wiley   +1 more source

Properties of cement screeds using recycled fine aggregates with respect to cement percentage

open access: yesActa Polytechnica CTU Proceedings
This article deals with the effect of 100% replacement of natural aggregate by recycled aggregate and at the same time the effect of cement percentage on the observed properties of cement screeds.
Leoš Joura
doaj   +1 more source

Effects of the Fine Recycled Concrete Aggregates on the Concrete Propertis

open access: yes, 2011
In this experimental study, the effects of the recycled fine recycled concrete aggregate (FRA) that was manufactured from concrete wastes on the concrete properties were investigated. In concrete mixtures, 0, 10, 20, 30, 40, 50 and 100% by weight FRA were used instead of river sand.
Yaprak, Hasbi   +4 more
openaire   +3 more sources

Properties Of Bricks Produced With Recycled Fine Aggregate

open access: yes, 2010
The main aim of this research is to study the possible use of recycled fine aggregate made from waste rubble wall to substitute partially for the natural sand used in the production of cement and sand bricks. The bricks specimens were prepared by using 100% natural sand; they were then replaced by recycled fine aggregate at 25, 50, 75, and 100% by ...
S. Ismail, Z. Yaacob
openaire   +2 more sources

Physics‐Constrained Constitutive Learning of Rate‐Limiting Timescales for Efficient Hydrogen‐Based Direct Reduction for Green Steel Making

open access: yesAdvanced Science, EarlyView.
A conversion‐resolved constitutive framework is developed for the hydrogen‐based direct reduction of iron oxide pellets. Effective reaction and transport timescales are inferred directly from measured trajectories and mapped against operating conditions, pellet architecture, and composition. The analysis reveals how late‐stage transport control emerges
Anurag Bajpai   +3 more
wiley   +1 more source

An Embodied Paper‐Based Microfluidic Al‐Air Battery for Enduring Untethered Insect‐Scale Robots

open access: yesAdvanced Science, EarlyView.
This work presents a centimeter‐scale microfluidic aluminum–air battery (MFAAB) with dual‐surface anode and F−‐mediated byproduct decomposition. The design enables a high capacity of 2697.05 mAh/g Al and delivers tens of milliwatts to power LEDs, motors, and a toy car.
Yun Yang   +5 more
wiley   +1 more source

A Supramolecular Reversible and Anisotropic Conductive Adhesive for Flexible Electronics

open access: yesAdvanced Science, EarlyView.
Supramolecular network‐based nanocomposites are developed as a stretchable conductive adhesive for flexible electronics. It's as convenient as traditional solders and constructs anisotropic conductive and robust stretchable connections among diverse soft/rigid materials.
Tongtong Li   +8 more
wiley   +1 more source

Home - About - Disclaimer - Privacy