Physical intrinsic characteristics of spheroidal particles in coal gasification fine slag
Spheroidal particles constitute the primary particulate signature within coal gasification fine slag (FS) residues. This research endeavor is centered on elucidating the physical configuration and intrinsic attributes of these spheroidal particles and ...
Li Yijin, Mao Lirui
doaj +1 more source
Experimental Study on De-ash of the Coal Gasification Fine Slag Based on Grinding Flotation
[Objective] Coal gasification slag is a bulk solid waste produced by the coal gasification process, which has become a prominent bottleneck restricting the high-quality development of the modern coal chemical industry. Flotation of coal gasification slag
Yanlin QIU, Zhenyang ZHAO
doaj +1 more source
UTILIZATION OF FERRO-NICKEL SLAG AS FINE AGGREGATE FOR CONCRETE
A total of eight ferro-nickel slags were studied for their possibility of being used as fine aggregate in concrete. Special emphases were placed on their effects on the freeze-thaw resistance and long-term stability of concrete. It was observed that the freeze-thaw resistance of slag concrete was generally lower than that of ordinary concrete with ...
Atsushi AKIYAMA, Yasuhiko YAMAMOTO
openaire +2 more sources
H2 prereduction selectively metallizes Fe in UG2 chromite pellets at 1100°C, while silicon carbide becomes active at 1300°C to convert remaining Cr2O3 to carbides and promote Cr metallization. By separating the roles of H2 and SiC, the sequential route reaches up to 65.7% Cr metallization and suppresses in‐furnace CO generation by ≈75% versus ...
D. Coertzen +5 more
wiley +1 more source
Incubation and pot experiments were carried out on muddy fine sand and fine sand soils to determine the efficiency of dolomitic limestone and of industrial by-products, basic slag and peat ash, as liming agents.
Raili Jokinen
doaj
Development of Performance Properties of Ternary Mixtures and Concrete Pavement Mixture Design and Analysis (MDA): Effect of Paste Quality on Fresh and Hardened Properties of Ternary Mixtures, TPF-5(117), 2012 [PDF]
The purpose of this study was to investigate the effect of cement paste quality on the concrete performance, particularly fresh properties, by changing the water-to-cementitious materials ratio (w/cm), type and dosage of supplementary cementitious ...
core
Characterization of Nonmetallic Inclusions in Ce‐Containing Steels at the Submicroscopic Level
Accurate detection of nonmetallic inclusions (NMIs) is crucial for ensuring high standards in steel cleanness and properties. Optimized automated SEM/EDS measurements are required for evaluating Ce‐containing NMIs. This study enhances the characterization of submicroscopic NMI in Ce‐alloyed ultralow‐carbon, high‐manganese, and electrical steels ...
Kathrin Thiele, Robert Musi
wiley +1 more source
Laboratory Investigation of Fatigue Characteristics of Asphalt Mixtures with Steel Slag Aggregates
There are many steel-manufacturing factories in Iran. All of their byproducts, steel slag, are dumped randomly in open areas, causing many environmentally hazardous problems.
Hassan Ziari +3 more
doaj +1 more source
Commercial iron ore sinter is reduced isothermally under operation‐derived radial blast furnace gas atmospheres with and without 20 kg H2/tHM injection. Hydrogen improves reduction at 900–1100 °C, whereas at 700 °C the high H2O content limits the wüstite‐to‐iron driving force.
Ahmed Abdelrahim +5 more
wiley +1 more source
Lightweight slag concrete with products of processing of ash and slag mixtures of Seversk CHP plant [PDF]
The paper presents research results of fine-grained concrete with products of processing of ash and slag materials. Not enough attention during the production of building materials paid to the ash and slag formed during the combustion of solid fuels, as ...
Корейбо, Н. В. +1 more
core

