Results 11 to 20 of about 8,525 (308)
Finish machining of hardened gears wheels using cubic boron nitride (CBN) inserts
Metalurgija, 2012 The paper presents some results of investigation of finish machining of hardened bearing surfaces of cylindrical gear wheels. Finish machining has been performed with wedges of defined geometry made of CBN. The presented investigation results are related
R. Talar, A. Stoić
doaj +1 more source
MQL Machining with nano fluid: a review
Manufacturing Review, 2021 In any metal cutting machining operation, the cutting fluid plays important role by cooling the cutting tool and the surface of the work piece, also chips are removed from heat affected zone.
Patole Pralhad B. +2 more
doaj +1 more source
Correlation between machining direction, cutter geometry and step-over distance in 3-axis milling: Application to milling by zones. [PDF]
, 2012 Computer-Aided Manufacturing (CAM) occupies an increasingly important role in engineering with all it has to offer in terms of new possibilities and improving designer/manufacturer productivity. The present study addresses machining of free-form surfaces
Senatore, Johanna +3 more
core +1 more source
Metals, 2021 Downsizing energy consumption during the machining of metals is vital for sustainable manufacturing. As a prerequisite, energy consumption should be determined, through direct or indirect measurement.
Rusdi Nur +4 more
doaj +1 more source
The Tool Path Tolerance Setting with Respect to Accuracy During 3axis Milling [PDF]
Journal of Systemics, Cybernetics and Informatics, 2021 Article describes CNC milling center programing during 3 axis finish milling. Article is focused on setting the tolerance of toolpaths during finish milling in CAM systems.
Marek Sadilek +4 more
doaj
Degradation modes and tool wear mechanisms in finish and rough machining of Ti17 Titanium alloy under high-pressure water jet assistance [PDF]
, 2013 This article presents the results of an experimental study on the Ti17 titanium alloy, which was carried out to analyze tool wear and the degradation mechanisms of an uncoated tungsten carbide tool insert. Two machining conditions, roughing and finishing,
GERMAIN, Guénaël +3 more
core +1 more source
Brittle–ductile transition during diamond turning of single crystal silicon carbide [PDF]
, 2013 In this experimental study, diamond turning of single crystal 6H-SiC was performed at a cutting speed of 1 m/s on an ultra-precision diamond turning machine (Moore Nanotech 350 UPL) to elucidate the microscopic origin of ductile-regime machining ...
Reuben, Robert L +5 more
core +1 more source
Surface profile prediction and analysis applied to turning process [PDF]
, 2008 An approach for the prediction of surface profile in turning process using Radial Basis Function (RBF) neural networks is presented. The input parameters of the RBF networks are cutting speed, depth of cut and feed rate.
LU, Chen, COSTES, Jean-Philippe
core +1 more source
Metals, 2023 This paper discusses a method of finish turning Inconel 718 alloy to compare machining performance of a naturally aged and used metalworking fluid (MWF), which had been conventionally managed through its life cycle, with the same new unaged product.
Paul Wood +8 more
doaj +1 more source
Pre-evaluation on surface profile in turning process based on cutting parameters [PDF]
, 2009 Traditional online or in-process surface profile (quality) evaluation (prediction) needs to integrate cutting parameters and several in-process factors (vibration, machine dynamics, tool wear, etc) for high accuracy.
MA, Ning +3 more
core +1 more source