Results 61 to 70 of about 187,850 (317)
Advanced Engineering Materials, EarlyView.Low‐temperature imidization of PEG‐modified polyimide enables fully screen‐printed, roll‐to‐roll fabrication of flexible electrodes on PET substrates, delivering robust mechanical durability and reliable ECG/EMG signal performance for wearable electronics.
Akib Abdullah Khan, Jong‐Hoon Kim
wiley +1 more source
Journal of Advanced Mechanical Design, Systems, and ManufacturingIn order to explore an efficient, accurate, and convenient finite element simulation method for laser peening forming, a square laser loading model was constructed by studying the loading feature unit of the circular spot superposition model, which can ...
Xu PEI, Boyong SU, Liang WANG
doaj +1 more source
Advanced Engineering Materials, EarlyView.A simplified thermoplastic pultrusion model is developed to predict thermal fields in glass fiber/polyethylene terephthalate (GF/PET) composites with reduced computational cost. By combining effective material homogenization, validation against literature data, and Gaussian‐process‐based optimization, the study reveals how heating limits, pulling speed,
Elder Soares +3 more
wiley +1 more source
A finite element model updating method for aqueduct structures based on Bayesian theory
Shuili Shuiyun Gongcheng XuebaoThe structural condition of aqueducts changes over time due to various influencing factors. Consequently, parameters used in finite element analysis may not reflect the real-time state of the structure.
WU Xijie +4 more
doaj +1 more source
Finite element model of Reisner’s plates in stresses
Инженерно-строительный журнал, 2019 A method for calculating bending plates by the finite element method based on Reisner's theory is proposed. The method is based on the fundamental principles of minimum of additional energy and possible displacements.
Yury Tyukalov
doaj +1 more source
Advanced Engineering Materials, EarlyView.Phase‐field simulations coupled with dislocation‐density‐based crystal plasticity modeling reproduce γ′ rafting behavior in single‐crystal Ni‐based superalloys under varied loading conditions. The model captures both macroscopic creep and microscopic morphology evolution, with results matching high‐temperature creep experiments.
Micheal Younan +5 more
wiley +1 more source
Finite Element Model Optimization Using Diagonal Mass Matrix
Shock and Vibration, 1997 By adjusting the analytic mass matrix or stiffness parameters, the correlation between measured and computed modal data can be improved. This article proposes a simple method for model optimization.
B.P. Wang, F.H. Chu
doaj +1 more source
A Composite Finite Element-Finite Difference Model Applied to Turbulence Modelling [PDF]
, 2007 Turbulence has been modeled by a two equation k-?turbulence model to investigate the wind induced circulation patterns in coastal waters. Predictions of the model have been compared by the predictions of two equation k-?turbulence model. Kinetic energy of turbulence is k, dissipation rate of turbulence is ?, and frequency of turbulence is ?.
Lale Balas, Asu Inan
openaire +3 more sources
Karl Popper and the Mechanisms of Hydrogen Embrittlement
Advanced Engineering Materials, EarlyView.Representation of the beginning of loss of ductility rather than embrittlement. Small concentrations of hydrogen in a diffusible form within iron are well‐established to harm the mechanical integrity of steels. There are theories that attempt to explain the pernicious role of hydrogen.
H. K. D. H. Bhadeshia
wiley +1 more source
International Journal for Computational Civil and Structural Engineeringhis article is devoted to the development of inconsistent finite element models of reinforcing rods for strength analysis of reinforced concrete structures.
Ivan Nesterov +2 more
doaj +1 more source