Results 81 to 90 of about 10,951 (204)

Auxiliary propulsion thruster performance with ion machined accelerator grids [PDF]

A substantial improvement in the performance of an 8-centimeter-diameter auxiliary propulsion thruster was achieved by reducing the diameter of the accelerator grid apertures.
Hudson, W. R.
core   +1 more source

Study on cutting trace shape control of machined surface by radius end mill with five-axis controlled machining center

, 2018
Toshiki HIROGAKI, Eiichi AOYAMA, Seigo Nakamura, Masahiro Uenoyama   +3 more
openalex   +2 more sources

C3 Generalization of Identification Method of Geometric Deviations for Five-axis Machining Centers with a Tilting-rotary Table(Multi-axis control machining)

, 2009
Naoki MIYAMA, Tomoyuki Saiki, Chengri Cui, Masaomi Tsutsumi   +3 more
openalex   +2 more sources

The upgrading of glass microballoons [PDF]

The processes and mechanisms involved in producing glass microballoons of acceptable quality for laser fusion by gas jet levitation and manipulation were studied.
Dunn, S. A., Gunter, S.
core   +1 more source

Consideration of optimizing rib shape for small size and high strength spiral bevel gear fabricated by five axis controlled machining center

, 2019
Shinya TOYOTA, Masahiro Saito, Takashi Shibata, Toshiki HIROGAKI, Eiichi AOYAMA   +4 more
openalex   +2 more sources

Improvement of machined accuracy under constant feed speed at milling point with a five axis controlled machining center considering approach path

, 2020
Takamaru Suzuki, Shoya Iwama, Toshiki HIROGAKI, Eiichi AOYAMA   +3 more
openalex   +2 more sources

Fabrication of composite propfan blades for a cruise missile wind tunnel model [PDF]

This report outlines the procedures that were employed in fabricating prototype graphite-epoxy composite prop fan blades. These blades were used in wind tunnel tests that investigated prop fan propulsion system interactions with a missile airframe in ...
Fite, E. Brian
core   +1 more source

S131023 Evaluation of dynamic errors of rotary axis in five-axis machining centers at the reversing Point

, 2011
Yusuke Ota, Soichi Ibaraki
openalex   +2 more sources

Influence of the Compliance of a Technological System on the Machining Accuracy of Low-Stiffness Shafts in the Grinding Process. [PDF]

Materials (Basel), 2023
Świć A, Gola A.
europepmc   +1 more source

Development of Table-on-Table-Type Five-Axis Machining Center: New Structure and Basic Characteristics

, 2011
Naoshi Takayama, Hidehito Ota, Kensuke UEDA, Yoshimi TAKEUCHI   +3 more
openalex   +1 more source