Results 21 to 30 of about 321 (183)

An Optimization-Based Approach for the Development of a Combustion Chamber for Residential Micro Gas-Turbine Applications

Chemical Engineering Transactions, 2015
In the field of micro gas turbine, attention must be paid on the design of the combustion chamber to reduce NOx formation without compromising combustion efficiency. To this goal flameless combustion represents an appealing solution.
V. Fortunato, E. Henrar, M. Delanaye, A. Parente   +3 more
doaj   +1 more source

Experimental investigation of flameless combustion of biodiesel

Energy, 2022
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Edson Orati, Anton S. Veríssimo, Ana Maura A. Rocha, Fernando S. Costa, João A. Carvalho   +4 more
openaire   +3 more sources

Clean Fuel, Clean Energy Conversion Technology: Experimental and Numerical Investigation of Palm Oil Mill Effluent Biogas Flameless Combustion

BioResources, 2015
The combustion of effluent biogas from a palm oil mill is not feasible on a large scale because of its low calorific value (LCV). Therefore, the captured biogas is usually flared because of a lack of appropriate combustion technology.
Seyed Ehsan Hosseini, Ghobad Bagheri, Mazlan Abdul Wahid, Aminuddin Saat   +3 more
doaj   +1 more source

Ignition and Self-Supporting Burning of Gas-Air Mixtures with Hydrogen Admixtures on Platinum Wire

Фізика і хімія твердого тіла, 2018
The proposed work describes analytical identification of hydrogen admixture concentration and catalyst temperatures limit values beyond which catalytic flameless steady combustion of gas-air mixtures at ambient temperature at platinum wires is observed ...
V.V. Kalinchak, A.S. Chernenko, A.N. Sofronkov, А.V. Fedorenko   +3 more
doaj   +1 more source

Influence of Thermal Diffusion on the Hysteresis Area of Hydrogen Impurities’ Catalytic Combustion on Platinum Wire

Фізика і хімія твердого тіла, 2018
A complex investigation of the hysteresis mechanisms of heat and mass exchange and catalytic flameless combustion of hydrogen-air mixtures on platinum’s particles and wires.
V. V. Kalinchak, A. S. Chernenko, A. N. Sofronkov, A. V. Fedorenko   +3 more
doaj   +1 more source

Numerical simulation of flameless combustion of multi-source low calorific value gas

Meitan xuebao
Fuel can be produced from biomass, municipal solid waste, low-grade coal and other raw materials through anaerobic fermentation, pyrolysis gasification and other technologies.
Beibei YAN, Xiaoyun LIU, Shengquan ZHOU, Guanyi CHEN   +3 more
doaj   +1 more source

Large-Eddy Simulation of flameless combustion with neural-network driven chemistry

Applications in Energy and Combustion Science, 2023
Large eddy simulation of a flameless combustion furnace is discussed with comparison against experimental measurements of the mean thermochemical quantities.
Huu-Tri Nguyen, Camille Barnaud, Pascale Domingo, Phuc-Danh Nguyen, Luc Vervisch   +4 more
doaj   +1 more source

Oxide Scale Morphology of Carbon Steels Under Novel Reheating Conditions

steel research international, EarlyView.
This study focuses on the changes in oxide scale morphology formed under simulated hydrogen and oxy‐fuel reheating gas atmospheres in comparison to natural gas‐air reheating. Several different properties were analyzed, such as pore structure, ratios of iron oxides, adhesion, and distribution of alloying elements.
Juho Haapakangas, Susanna Airaksinen, Eetu‐Pekka Heikkinen, Timo Fabritius   +3 more
wiley   +1 more source

Effect of Mechanical Activation on the Reactivity of Composites for Flameless Heaters

Eurasian Chemico-Technological Journal, 2020
The work is devoted to the activation of metal powder mixtures suitable for use in flameless food heaters. Four activated powders have been manufactured starting from the reference material using a standard technique.
A. Kaliyeva, Ye. Tileuberdi, L. Galfetti, Ye. Ongarbayev   +3 more
doaj   +1 more source

DSC can be used to determine the enthalpies of formation for the 3d transition metal oxalates

Chemical Thermodynamics and Thermal Analysis, 2022
Differential scanning calorimetry has been used to measure the enthalpy of formation for manganese, iron, cobalt, nickel, copper and zinc oxalate. By adding a flameless combustion catalyst (CuO) and using scans of 2 K min−1 in static air, the values ...
Rafael Snell-Feikema, Barbara A. Reisner, Thomas C. DeVore   +2 more
doaj   +1 more source