Results 91 to 100 of about 18,934 (212)
Standardized solar simulator tests of flat plate solar collectors. 1: Soltex collector with two transparent covers [PDF]
A Soltex flat plate solar collector was tested with a solar simulator for inlet temperatures of 77 to 201 F, flux levels of 240 and 350 Btu/hr-sq ft, a collant flow rate of 10.5 lb/hr sq ft, and incident angles of 0 deg, 41.5 deg, and 65.2 deg. Collector
Simon, F.
core +1 more source
EAI Endorsed Transactions on Energy WebSmall sized absorber in a flat plate solar collector is beneficial in terms of cost and minimum heat losses. However, its detailed thermal performance compared to standard size collector is still not fully understood.
Kumar Aditya Chandra +3 more
doaj +1 more source
Solar water heating system for a lunar base [PDF]
An investigation of the feasibility of using a solar water heater for a lunar base is described. During the investigation, computer codes were developed to model the lunar base configuration, lunar orbit, and heating systems.
Haynes, R. Daniel, Somers, Richard E.
core +1 more source
iRASD Journal of Energy & EnvironmentThis study presents a detailed techno-economic and thermal performance evaluation of a solar-assisted absorption cooling system optimized for the climatic conditions of Peshawar, Pakistan.
Abid Hussain +5 more
doaj +1 more source
A preliminary test of a flat-plate solar collector of hybrid solar water heater [PDF]
Journal of Physics: Conference Series, 2018 H Ambarita +3 more
openaire +1 more source
Index to 1981 NASA Tech Briefs, volume 6, numbers 1-4 [PDF]
, 1986 Short announcements of new technology derived from the R&D activities of NASA are presented. These briefs emphasize information considered likely to be transferrable across industrial, regional, or disciplinary lines and are issued to encourage ...
core +1 more source
Solar hot water system installed at Quality Inn, Key West, Florida [PDF]
The solar energy hot water system installed in the Quality Inn, Key West, Florida, which consists of four buildings is described. Three buildings are low-rise, two-story buildings containing 100 rooms.
core +1 more source
Measured performance of a 3 ton LiBr absorption water chiller and its effect on cooling system operation [PDF]
A three ton lithium bromide absorption water chiller was tested for a number of conditions involving hot water input, chilled water, and the cooling water.
Namkoong, D.
core +1 more source
Index to NASA Tech Briefs, 1975 [PDF]
, 1976 This index contains abstracts and four indexes--subject, personal author, originating Center, and Tech Brief number--for 1975 Tech ...
core +1 more source
Evaluation of flat-plate collector efficiency under controlled conditions in a solar simulator [PDF]
The measured thermal efficiencies of 35 collectors tested with a solar simulator, along with the correlation equations used to generalize the data, are presented.
Johnson, S. M., Simon, F. F.
core +1 more source