Results 1 to 10 of about 4,753 (289)
Bulletin of the Polytechnic Institute of Jassy: Constructions, Architechture Section, 2008 Roofs are constructive subassemblies that are located at the top of buildings, which toghether with perimetral walls and some elements of the infrastructure belongs to the subsystem elements that close the building.
Şt. Vasiliu
doaj +3 more sources
Application of recycled plastic in flat roofs [PDF]
MATEC Web of Conferences, 2018 The article describes and verifies the possibility of applying secondary plastic materials to construction details such as flat roofs. The created element is a placement considered both in the area and in the finishing detail.
Smolka Radim, Sobotka Jindřich
doaj +5 more sources
Bulletin of the Polytechnic Institute of Jassy: Constructions, Architechture Section, 2009 Roofs are constructive subassembles that are located at the top of buildings, which toghether with perimetral walls and some elements of the infrastructure belongs to the subsystem elements that close the building. Roofs must meet resistance requirements
Şt. Vasiliu
doaj +2 more sources
Polyurethane adhesives in flat roofs [PDF]
MATEC Web of Conferences, 2017 It is necessary to stabilize individual layers of flat roofs, mainly because of wind suction. Apart from anchoring and surcharge, these layers can be secured by bonding. At present gluing is an indispensable and widely used stabilization method.
Bogárová Markéta +2 more
doaj +4 more sources
Deep learning applied to equipment detection on flat roofs in images captured by UAV [PDF]
Case Studies in Construction Materials, 2023 Maintenance on flat roofs is a complex activity. Equipment improperly positioned on flat roofs hinders the correct drainage of water and makes maintenance services more difficult.
Lara Monalisa Alves dos Santos +3 more
doaj +2 more sources
DERIVATION OF BUILDING STRUCTURES FROM NOISY DIGITAL SURFACE MODELS [PDF]
The International Archives of the Photogrammetry, Remote Sensing and Spatial Information Sciences, 2023 In this work we present a novel approach for segementation of a noisy DSM to building structures and other non-building structures – normally trees – and the modeling of them. Mostly Digital Surface Models (DSMs) from only a few aerial images
T. Krauß
doaj +1 more source
Modular and Prefabricated System for Waterproofing and Insulation of Flat Roofs
Buildings, 2023 Recently, there has been an attempt to implement increasingly significant prefabrication in building construction, since this method is considered to represent an opportunity to reduce impacts in the construction sector.
Patrícia Fernandes Rocha +3 more
doaj +1 more source
Snow Load Shape Coefficients and Snow Prevention Method for Stepped Flat Roofs
Applied Sciences, 2023 Excessive snow load and nonuniform snow deposition are the main factors leading to building collapses. The snow load shape coefficient represents the dimensionless snow load, and its value is related to the unbalanced distribution of snow.
Zhibo Zhang +3 more
doaj +1 more source
Journal of Air Pollution and Health, 2023 Introduction: Coupling the indoor and outdoor airflow of roadside buildings in a street canyon, the impact of flat and triangular roofs on indoor air pollutant concentration and ventilation rates of naturally ventilated buildings is studied using ...
Haiying Xie, Tianxiao Zhang
doaj +1 more source
Analysis of the causes of defects due to quality roofing membranes mechanical anchoring [PDF]
MATEC Web of Conferences, 2017 Anchoring of the layers of flat warm roofs using anchoring elements is nowadays one of the most used technology. This is a frequent technology to repair damaged roofs (total reconstruction, increasing the load on the wind loads, partial repairs etc.). In
Stodůlka Jindřich +2 more
doaj +2 more sources