Results 1 to 10 of about 106,281 (264)

Comparative Study of Tube in Tube Flat Slab with Tube in Tube Waffle Slab, Structures Under the Sesmic Loads

International Journal for Research in Applied Science and Engineering Technology, 2021
Abstract: The tube in tube structure is one of the type that is been broadly used as structural system for tall structures. Considering the lateral loads due to the seismic force it gives more stiffness and gives more strength to the high-rise structures.
openaire   +1 more source

Elastomer-constrained flat tube actuators (EFTAs)

Intelligent Service Robotics
Abstract Ethylene–vinyl acetate (EVA) flat tube has been widely used in designing soft wearable robots because of low-cost material, easy fabrication, and large deformation. However, only a bending-type flat tube actuator was proposed in previous studies, and more deformation modes are required to satisfy diverse robot design requirements ...
Senyuan Lin, Hao Liu 0084, Changchun Wu, Yunquan Li, Lixi Huang, Yonghua Chen   +5 more
openaire   +1 more source

Wearable fluid power composed of transformed flat tube actuators [PDF]

IEEE/RSJ International Conference on Intelligent Robots and System, 2003
This paper presents a novel approach of driving the human joints by means of a fluid control system with flexibility just like clothes, which leads to a cyborg amplifying the human motor function. Former actuators for body mounting were not always designed from the point of clothing comfort.
H.Tsukagoshi, A.Kitagawa, Y.Kamata
openaire   +1 more source

Deformation and Stresses of Flat-Oval Bourdon Tubes

Bulletin of JSME, 1967
To the problem of deformation and stresses of flat-oval Bourdon tubes, a numerical difference method is applied, which was proposed by W.K. Sepetoski and others, and useful design charts and formulas for evaluating their sensitivity and stresses are obtained.
HAMADA, Minoru, FUJITA, Katsuhisa, ASAHINA, Kiyoshi   +2 more
openaire   +2 more sources

Flatness based control of a ball in tube system

IFAC-PapersOnLine, 2015
Abstract This paper deals with the derivation and the implementation of a flatness based control for a nonlinear ball in tube system as a testbed. For this purpose the system equations are quoted, considering that the system properties are changing in dependence on a positive or a negative fan acceleration.
Herrmann, Lukas, Broecker, Markus
openaire   +1 more source

Study on the Pressure Bearing Capability of Folded Multi-Port Flat Tube. [PDF]

Materials (Basel), 2019
Tang D, Chen X, Zhao L, Zou T, Wang H, Li D, Peng Y, Wu P.   +7 more
europepmc   +1 more source

EXPERIMENTAL INVESTIGATION ON THE CONDENSATION OF R134A IN MULTIPORT FLAT TUBES

International Heat Transfer Conference 16, 2017
Knipper, P., Bertsche, D., Wetzel, T.
openaire   +2 more sources

Response of curved laminated glass under quasistatic and blast loads. [PDF]

Sci Rep
Elgholmy L, Elbelbisi A, Elsisi A, Bowman A, Salim H, Perry K, Meier J.   +6 more
europepmc   +1 more source

Technical strategies for radiation dose optimisation in paediatric pelvic radiography: a systematic review. [PDF]

Radiol Phys Technol
Kamath K, Sukumar S, David LR, Kadavigere R, Shah HH, Panakkal NC, Pradhan A, Dkhar W, Planiswamy HP, Ravichandran S, Shettigar D, Muthu SS.   +11 more
europepmc   +1 more source

Simplification of Low-Cycle Creep-Fatigue Load Spectrum of Combustion Chamber and Life Assessment for Feature Simulation Specimens. [PDF]

Materials (Basel)
Cheng D, Zhao H, Zhang Q, Chen M, Zhao H, Hou C.   +5 more
europepmc   +1 more source