Results 181 to 190 of about 442,336 (300)
This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
Preparation and Applications of Silver Nanowire-Polyurethane Flexible Sensor. [PDF]
Shan J +5 more
europepmc +1 more source
Transcutaneous Flexible Sensor for In Vivo Photonic Detection of pH and Lactate. [PDF]
Nguyen D +7 more
europepmc +1 more source
Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source
Flexible Sensor with Material-Microstructure Synergistic Optimization for Wearable Physiological Monitoring. [PDF]
Mou Y +6 more
europepmc +1 more source
Four-Level Micro-Via Technology (4LµV) for ASIC Integration in Active Flexible Sensor Arrays. [PDF]
Zhou M, von der Heide C, Dietzel A.
europepmc +1 more source
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Photopolymerization 3D-Printed Dual-Modal Flexible Sensor for Glucose and pH Monitoring. [PDF]
Lin S +8 more
europepmc +1 more source
A wearable, flexible sensor for real-time, home monitoring of sleep apnea. [PDF]
Honda S +4 more
europepmc +1 more source
Assessing Altered Coating Adhesion on Plasma‐Deoxidized Surfaces Under Oxygen‐Free Conditions
This study demonstrates the effectiveness of atmospheric pressure plasma pretreatment in modifying silicon and stainless steel surfaces to improve adhesion. Argon‐hydrogen plasma increases surface roughness and improves adhesion strength, whereas pure argon results in smoother surfaces and structural changes.
Selina Raumel +6 more
wiley +1 more source

