Results 31 to 40 of about 8,957,031 (293)
Flexural performance evaluation of slab using welded bar mat
Journal of Asian Architecture and Building Engineering, 2023 This is an experimental study on flexural performance evaluation when welded bar mats (WBM), which improve the rib shape, strength, and diameter limits of the existing structural welded wire fabric (WWF), are applied to slabs.
Geon-Ho Hong, Seong-Won Jung
doaj +1 more source
BuildingsTo meet the requirements of a prefabricated building with specific strength limitations and assembly rate criteria, the research proposes a Low-Strength Foamed Concrete Cold-Formed Steel (CFS) Framing Composite Enclosure Wall Panel (LFSW).
Xinliang Liu +3 more
doaj +1 more source
The performance comparison of Oxford and triangle flexure bearings [PDF]
AIP Conference Proceedings, 2012 Flexure bearings are widely used in linear compressors because of their high radial stiffness and long life. In this paper, a Finite Element Method (FEM) is employed to analyze the characteristics of Oxford and triangle flexure bearings. These two kinds of plate springs are analyzed separately by changing the load, thickness and width of the spring arm,
Wenjie Zhou +5 more
openaire +1 more source
Flexural Performance of Steel–GFRP Strips–UHPC Composite Beam in Negative Moment Region
BuildingsThis study aims to clarify the longitudinal flexural cracking characteristics in hogging moment regions and propose a practical calculation method for the cracking load and ultimate bearing capacity for a steel–GFRP strips–UHPC composite deck structure ...
Lei Cao +6 more
doaj +1 more source
Flexural–torsional behavior of thin-walled composite box beams using shear-deformable beam theory [PDF]
, 2008 This paper presents a flexural–torsional analysis of thin-walled composite box beams. A general analytical model applicable to thin-walled composite box beams subjected to vertical and torsional loads is developed.
Lee, Jaehong, Vo, Thuc
core +1 more source
Chengshi guidao jiaotong yanjiu［Objective］The transverse joints within the panels of prefabricated diaphragm walls are the weak points in the entire wall structure. Therefore, it is necessary to study the stiffness and strength characteristics of these joints.
CUI Tao
doaj +1 more source
Determination of the spring constants of the higher flexural modes of microcantilever sensors [PDF]
, 2013 Funding: University of St Andrews.A method for the simultaneous calibration of the spring constants of all flexural modes of microcantilevers is presented. It is based on a flow of gas from a microchannel that interacts with the microcantilever.
Hähner, Georg +2 more
core +1 more source
Modelling flexural performance of hollow pultruded FRP profiles
, 2021 Hollow Pultruded Fibre-Reinforced Polymer (PFRP) profiles, as novel construction material, require further development of design tool to broaden the applications.
Mohammad, Ali +13 more
core +1 more source
BuildingsThe influence of the carbonation of recycled coarse aggregates on the durability performance of the recycled aggregate concrete beams is still unclear.
Guixiang Yi +3 more
doaj +1 more source
Enhancing and Decoding the Performance of Muscle Actuators with Flexures
Advanced Intelligent SystemsLeveraging living muscle as an efficient and adaptive actuator for soft robots has been of increasing interest over the past decade, with a focus on proof‐of‐concept demonstrations of function. Reproducible design and scalable manufacturing of biohybrid machines requires methods to increase the stroke output of strain‐limited muscle actuators and ...
Naomi Lynch +6 more
openaire +3 more sources